Tabla de contenido
Idiomas disponibles
Idiomas disponibles
8.3.2
Cleaning round or angled upward sliding doors
1. Close the re compartment door (slide down fully).
Place the "cold hand" on the slide rail locking
mechanism above the re compartment door.
2. (Attention! One- or two-sided, depending on model)
( g.8.5.4).
3. Twist to the right to push the bolt for the locking
mechanism forward by 90 degrees (to under the
door cover).
4. Turn the lever to right to lock the lifting mechanism.
5. Place the "cold hand" on the lever locking device
on the right hand side of the door and twist upward
( g.8.5.5).
6. Swing open the door for cleaning ( g.8.5.6).
1. Gently close the re compartment door and hold,
apply slight pressure.
2. Place the "cold hand" on the catch located to the right
of the door and twist back downward to the end stop.
3. Free the sliding rail again by twisting the locking
mechanism to the left.
4. Test the proper operation of the door by sliding upward
and re-check the catch to ensure the latter is closed
up to its end stop. After cleaning, close the replace
insert door again, place the "cold hand" on the square
stub, apply closing pressure to the door frame (not the
glass) and lock the door by twisting the "cold hand"
downward. Remember to reset the sliding rail locking
mechanism.
8.3.3
Cleaning of angled doors (3-sided)
Clean only when cold, as per the versions below.
1. Slide down the re compartment door fully!
2. Using the "cold hand", twist open the catch for the
sliding rail locking mechanism, located above the re
compartment door, right and left. The door is now
locked in bottom position.
3. Another locking bolt is located on the opposite side
( g.8.5.7).
4. Release the lateral door catches by hand, or with
the "cold hand", by twisting – observe the sequence!
Important: First release the bottom catch, then the top
one. (the top catch supports opening)
5. First twist open the bottom catch ( g.8.5.8).
6. Then twist open the top catch ( g.8.5.9).
7. Swing open the replace doors to the left and or
right ( g.8.5.10). Now clean the glass pane as per
the instruction manual. Handle the doors by their
frames only!
- 8.5.4 -
- 8.5.5 -
- 8.5.6 -
- 8.5.7 -
- 8.5.9 -
- 8.5.8 -
- 8.5.10 -
Tabla de contenido
