How Do I Load A Roll Of Paper - HP Designjet 130 Serie Guía De Referencia Rápida

HP Designjet 130/130nr Printer - Quick Reference Guide

How Do I Load a Roll of Paper?

This section is only relevant if your printer has the Automatic Roll Feed installed.
Only one source of paper can be used by the printer at any one time, so if a
roll of paper is loaded in the printer and you want to print to a sheet of paper,
you must first unload the roll. The roll is automatically reloaded the next time
printing to the roll is requested.
You can cut a roll without unloading it by pressing the OK key (top right key on
the front panel); the paper first advances about 1 cm or 0.4 inch.
1. Set your application to pick paper from the roll feed.
2. Select Print from your application.
3. Load a roll of the required paper onto the spindle. Ensure that the roll is the
right way round and that the blue stop on the spindle is pushed in against
the paper.
4. Insert the spindle into its retaining slots, with the blue stop on the right and
the black stop on the left as seen from the rear of the printer.
If the paper is glossy, we recommend that you wear gloves to avoid
smearing the surface of the paper.
5. Make sure that the leading edge of the roll is straight and perpendicular to
its side edges and has no irregularities.
...continued on next page...
8