Removing The Camber Tube - Ki Mobility Little Wave Clik XP Manual De Instrucciones Y Garantía

V. SET UP & USE OF YOUR WHEELCHAIR
L. Removing the Camber Tube
Removing the Camber Tube on your Clik (Fig. 14)
1. Remove rear wheels.
2. Remove 6mm screw (Fig. 14:D) using two Allen wrenches.
3. Press threaded barrel (Fig. 14:E) through camber tube using Allen wrench.
4. Loosen 6mm screw (Fig. 14:A) to release clamp.
5. Loosen set screws (Fig. 14:B).
6. Slide camber adapter (Fig. 14:G) from end of camber tube (Fig. 14:C).
7. Repeat steps 2 - 6 on other side.
8. If your chair has a Standard or Dynamic 5th wheel, refer to corresponding steps (a - d)
below before moving on to step 9. If your chair does not have a Standard or Dynamic 5th
wheel skip to step 9.
Instructions for removal with STANDARD 5th Wheel (Fig. 15):
a. Remove 5th wheel from receiver and set aside.
b. Remove 5mm bolt from receiver (Fig. 15:A).
c. Loosen two 6mm clamping screws (Fig. 15:B) until receiver slides freely on camber tube.
d. Move to step 9.
Instructions for removal with Dynamic 5th Wheel (Fig. 16):
a. Remove 5th wheel from receiver and set aside.
b. Remove two 6mm bolts from receiver (Fig. 16:A).
c. Receiver can now slide on to the camber tube.
d. Move to step 9.
9. Slide camber tube to left or right to remove from camber tube clamps. If you have a 5th wheel
receiver you need to remove from camber tube at this time.
Fig. 15
Fig. 16
26
B
A
A