Urrea SM1113 Manual De Usuario página 19

This picture shows the
location for the brace
location.
2. Motor cover install.
Install the door by in-
serting the door pins
into the hinge sockets
on the cabinet.
3. Handwheel handle
install. Install the han-
dle into the blade tilt
& height hand wheel.
4. Extension wings install.
a) Remove the screws
from the ends of the
main table (fig.4).
b) Inspect the exten-
sion wings and main
table mating surfaces
for burrs or foreign materials that may inhibit
assembly.
c) The mating edges of the wings and the table
must be clean, smooth, and flat, use a wire
brush or file if necessary to clean up the edg-
es, this step will ensure that the wings mount
properly to the main table.
d) Attach the wings to the main table with the
screws removed in step 'a'.
e) Place the straightedge across the extension
wings and main table to make sure that the
table surface is flat. If the outside end of ex-
tension wings tilts down Or up, use a strip of
masking tape to shim the extension wing up
or down.
Fig.1
Fig.2
Fig.3
Fig.4
E N G L I S H •
5. Install the rail & fence (extension table)
a) Install the front rail
onto the table and
extension wings with
four M8-1.25x40 hex
bolts, eight 8mm flat
washers, four 8mm lock washers, and four M8-
1.25 hex nuts, as shown in figure 5.
b) Install the front
rail rectangular tube
onto the 50" front
rail with the M6-1 x
16 cap screws, 6mm
flat washers, and 6mm
lock washers, as shown in figure 6.
c) Attach the rear rail
to the holes on the
main table using two
5⁄16"-18 x 1" hex bolts,
8mm lock washers and 8mm flat washers, as
shown in figure 7, secure the rear rail to the ex-
tension wings with two M8-1.25 x 40 hex bolts,
four 8mm flat washers, two 8mm lock washers
and two M8-1.25 hex nuts.
NOTE: Before tight-
ening the fasteners,
check to make sure
the top edge of rear
rail is flush with the
lowest edge of both
T-bolts, so the miter
gauge will slide smoothly when installed later.
d) Install the extension table between the
front and rear rails as figures 8 and 9.
Fig.8
e) Place the fence on the rails on the right hand
side of blade.
NOTE: Make sure the cam foot contacts the
cam on the fence lock handle before you place
the fence on the rail, otherwise the fence will
not lock into the rail tube.
c) Checking fence parallelism.
· Slide the fence along the rail , if it drags across
the table, then adjust the foot at the rear of
the fence to raise the fence off of the table just
enough, so that the gap between the fence,
and the table is even from front to back.
U s e r's m a nu al
Fig.5
Fig.6
Fig.7
Fig.9
Install table extension.
19