Manufacturer's Warranty - Hilti TE 60-AVR Manual De Instrucciones Original

Trouble or fault
The tool does not achieve full
power.
The drill bit does not rotate.
The drill bit cannot be re-
leased.
The power tool doesn't start.
The service indicator lights.
The service indicator blinks.
9 Disposal
Most of the materials from which Hilti tools and appliances are manufactured can be recycled. The
materials must be correctly separated before they can be recycled. In many countries, your old tools,
machines or appliances can be returned to Hilti for recycling. Ask Hilti Service or your Hilti representative
for further information.
▶ Disposal of electric tools or appliances together with household waste is not permissible.

10 Manufacturer's warranty

▶ Please contact your local Hilti representative if you have questions about the warranty conditions.
10 English
Printed: 28.06.2017 | Doc-Nr: PUB / 5277952 / 000 / 01
Possible cause
The control switch is not fully
pressed.
The voltage provided by the elec-
tric supply is too low.
The reduced-power (50% power)
button is engaged.
The function selector switch is
not correctly engaged, is set to
"Chiseling" , or is set to "Chisel
positioning" .
The chuck is not pulled back fully.
The side handle is not fitted cor-
rectly.
Interruption in the electric supply.
The electronic restart interlock is
activated after an interruption in
the electric supply.
The supply cord or plug is defec-
tive.
The detachable supply cord is not
fitted correctly.
Generator with sleep mode.
The carbon brushes are worn.
Damage to the power tool or ser-
vice limit time reached.
Action to be taken
▶ Press the control switch as far
as it will go.
▶ Connect the combihammer to a
different electric supply.
▶ Press the reduced-power
button.
▶ Move the function selector
switch to the "Hammer drilling"
position while the motor is
not rotating.
▶ Pull the chuck back as far
as it will go and remove the
accessory tool.
▶ Release the side handle and refit
it correctly so that the clamping
band and side handle engage in
the recess.
▶ Plug in another electric tool or
appliance and check whether it
works.
▶ Switch the power tool off and
then on again.
▶ Have the supply cord or the plug
checked by a trained electrical
specialist and replaced if
necessary.
▶ Fit the detachable supply cord
to the power tool correctly.
▶ Apply a load to the generator
by connecting a second power
consumer (e.g. worklight).
Switch the tool off and then on
again.
▶ Have the power tool checked by
a trained electrical specialist and
the carbon brushes replaced if
necessary.
▶ Have the product repaired by
Hilti Service.