Putting Into Operation - Abicor Binzel ROBO WH Serie Instructivo De Servicio

WH and WHPP

6 Putting into operation

6.1 Equipping the ROBO WH 241D, WH 455D torch neck
1
1 Gas Nozzle
2 Welding spatter guard
Fig. 7 Equipping the ROBO WH 241D and ROBO WH 455D torch neck
DANGER
Risk of injury due to unexpected start-up.
For the entire duration of maintenance, servicing, dismounting and repair
work, the following instructions must be adhered to:
• Switch off the power supply.
• Cut off the compressed air supply.
• Pull the mains plug.
NOTE
• The welding torch system WH/WHP may only be put into operation by
trained personnel.
All torch necks are available optionally with sensor. For the control line
connection, please refer to the connection diagram.
2 3 4
3 Contact tip
4 Tip adaptor
1 Screw the replaceable tip adaptor (4) into the torch neck (5) .
2 Screw the contact tip (3) into the tip adaptor (4) and tighten it using a
multiple wrench.
3 Screw the welding spatter guard (2) into the torch neck (5).
4 Slide the gas nozzle (1) on the torch neck (5) rotating it slightly clockwise.
5 Screw in the ready-to-use equipment kit (6) on the connection side.
5
5 Torch neck
6 Equipment kit
6 Putting into operation
6
EN - 11