GYS TIG 168 DC HF Manual De Instrucciones página 20

MADE IN FRANCE
Recommended combinations / Electrode grinding
0,5-5
4-6,5
> 6.5
To optimise the welding process, it is recommended to grind the electrode prior to welding as described in the diagram
below :
L = 3 x d for a low current
L = d for a high current.
Trigger command connector
The trigger command socket is laid out in the following way:
TIG 200
1- Switch GND + Potentiometer
2- Cold current button
3- Welding torch button
4- Cursor / potentiometer
5- +5V potentiometer 10 KΩ
TIG 168
1- Switch GND
2- Cold current button
3- Welding torch button
REMOTE CONTROL (TIG 200 ONLY)
The remote control operates in TIG and MMA mode.
Connector technology
The TIG 200 is equipped with a female socket for a remote control. The specific 7 point male plug (GYS product
ref.045699) enables connection to a manual remote control (RC) or foot pedal (PEd).
For the cabling lay out, see the diagram below.
ref. 045699
Connecting remote/pedal
1- Power up the machine
2- Plug the pedal/remote control to the connecting socket on the machine.
3- The screen will flash and display « No » (Nothing),
4- Select the type of control by turning the intensity adjustment knob:
« No » (Nothing) / « RC »
5- Turn the knob until the desired selecton is reached, and after 2 seconds the display will freeze on the chosen selec-
tion.
Nb. : In case of error, unplug the remote control, ( « No » will be displayed) and re-start the connection
process.
Remark: You will be asked to specify the remote connected each time the machine is powered up.
20
TIG 168 DC HF/ TIG 200 DC HF FV
Ø Electrode (mm)
Current (A)
= Ø wire (filler metal)
10-130
130-200
> 200A
(Remote Control) / « PEd »
Ø Nozzle (mm)
1,6 9,8
2,4 11
3,2 12,7
d
2
3
4
1
1
4
5
D : Switch contact
C : Earth
B : Cursor
A : + 5V
Nb : The Potentiometer value must be 10 KΩ
(Pedal)
Flow rate
(Argon L/mn)
6-7
7-8
8-9
L
2
5
3
EN