Operating Controls; Intended Use; Inserting/Replacing The Saw Blade; Initial Operation - Würth Master STP 85 Instrucciones Para El Manejo

Operating Controls

1 Rotating handle with push-button
2 Thumbwheel for preselecting
3 Allen key

4 ON/OFF switch

5 Base plate
6 Adjusting lever for sawdust blower
7 Adjusting lever for pendulum lift
8 Guiding roller
9 Saw blade*
10 Lifting rod
11 Contact protector
12 Scale
13 Screw for footplate
14 Positioning pin
15 Bolt holes
16 Anti-splintering device
17 Circle cutter/Parallel guide*
*Accessory
*Not all of the accessories illustrated or described are included
as standard delivery.

Intended Use

The machine is intended for making separating cuts
and cutouts in wood, plastic, metal, ceramic plates
and rubber while resting firmly on the workpiece. It
is suitable for straight and curved cuts with mitre an-
gles to 45°.
The saw blade recommendations are to be observed
Inserting/Replacing the Saw
Before any work on the machine itself, pull the
plug from the socket!
The machine is equipped with a quick-clamping de-
vice. This makes possible easy and quick changing
of the saw blade without additional tools.
Before changing saw blade 9, set adjusting lever for
pendulum lift 7 to step III.
Depress the orange-coloured push-
1.
button until it clicks into position
Turn clic handle 1 three rotations in
2. 3x
anti-clockwise direction
12
Blade
Insert saw blade 9 in blade holder 10
3.
at a right angle to the cutting direc-
tion, turn saw teeth toward cutting di-
rection whilst raising blade slightly,
thus guiding the back of the saw
blade into the groove in guide roll-
er 8. Snap it into place with a light
tug.
Rotate clic handle 1 in clockwise di-
4.
clic
rection until a snap is heard (click).
Then push the orange-coloured push-
5.
button back to the initial position.

Initial Operation

Always use the correct supply voltage: The power
supply voltage must match the information quoted
on the tool identification plate. Tools with a rating of
230 V can also be connected to a 220 V supply.
ON/OFF switch
Switching on: Slide ON/OFF switch 4 fowards
(position I = ON).
Switching off: Slide ON/OFF switch 4 backwards
(position 0 = OFF).
Stroke rate preselection
The required stroke rate can be preselected (also
during operation) using the thumbwheel 2.
1 – 2 = low stroke rate
3 – 4 = medium stroke rate
5 – 6 = medium stroke rate
The stroke rate required depends upon the material
and the working conditions. The optimal setting can
be determined in practice.