D - Cleaning The Clean Water Filter; E - Replacing The Brush; F - Replacing The Squeegee Rubber Blades; G - Cleaning The Recovery Water Tank - Ghibli ROUND 45 E 55 TOUCH Instrucciones De Uso

EN
OPERATIONS TO
PERFORM WHEN
NECESSARY

9.1.d - Cleaning the clean water filter

(Fig. 15)
NOTE:
Before cleaning the filter, make sure the
clean water tank is empty.
- Unscrew and remove the cover (49).
- Remove the filter (17) and wash it in run-
ning water.
- Refit the filter (17) in its seat, then tighten
the cover (49).

9.1.e - Replacing the brush

(Fig. 6-16)
It is necessary to replace the brush when it is
worn more than 2 cm or it must be replaced
depending on the type of floor to be washed;
to replace it proceed as follows:
- Lift up the brush using the pedal as
shown in the relative paragraph.
- Insert a hand under the brush holder unit
(51 Fig. 16); to release the brush, turn it
abruptly in the direction of rotation.
- Replace the brush, coupling it manually
to the brush holder flange (51 Fig. 16).
- Lower the brush, acting on the pedal, as
shown in the respective section.
- Press switch (34 Fig. 6) to position "I".
- Press the switch (38 Fig. 6) to enable the
rotation of the brushes.
- Act on the touch sensor (20) positioned
on the handle to start the rotation of the
brush.
- Turn off the machine by pressing the
switch (34 Fig. 6) on "0".
9.1.f - Replacing the squeegee
rubber blades (Fig. 17)
When it becomes clear that drying the floor
is difficult or traces of water remain on the
floor, it is necessary to check the wear on the
squeegee rubber blades (50):
- Remove the squeegee unit (11) as in-
dicated in the "Cleaning the squeegee"
paragraph.
- Press the locking device (52) and open
the handle (53).
- Remove the two rubber mounting strips
(54) and remove the outer rubber (55).
- Loosen the two turnbuckles (56) and re-
move the locking bar (57) and the inside
rubber (58).
N.B.:
When the rubber blades (55) or (58) are worn
on one side, on one occasion they may be
turned over.
- Replace or turn over the rubber blades
(55) or (58) without inverting them.
- Replace all the components in reverse
order.
N.B.:
It is possible to have two types of rubber
blade.
Para rubber blades for all types of floor and
polyurethane rubber blades for mechanical
workshop floors which are dirty with oil.
9.1.g - Cleaning the recovery water
tank (Fig. 18)
Remove the upper cover to access inside the
recovery water tank.
- Loosen the knob (59) and remove the fil-
ter (60).
- Wash the filter (60) with running water
and replace it in the machine, tightening
the knob (59).
- If the filter (60) is particularly dirty you can
open it by levering with a screwdriver on
the coupling claw (61).
EN-10
9.1.h
- Li
- Lo
filt
- W re
9.1.i
Repla
same
- Re
so
- Re
in
fu
- Re
fu
9.1.l
- It
wi
bl
Heigh
- Th
st
on
- Lo
th
de
(6
Incid
- Lo
- St
m
st
- Ch
bl
Fi
Fi
Fi
- Us
tu
in
cr