Introduction; General; Technical Specification - Dedicated Micros drx 400 Manual De Instalación

2. Introduction

GENERAL

The drx 400dc receiver has been designed to control a d.c. Pan & Tilt Head or Surveillance Dome
and offers three latching auxiliary relay outputs plus one un-switched output which are used to
control: Wash, Wipe and Illuminator. Control of the lens functions is also provided with adjustable
6 to 12 Volt d.c. drives plus an adjustable inching facility. Stores up to 16 full preset positions with
8 alarm inputs and one N/C alarm output (with programmable delay).
A Camera power outlet is also available.
Telemetry data signals can be either "up the coax" or twisted pair 20 mA current loop
As standard the unit is pre-wired for 230Volt a.c. supply can be converted to 110 Volt operation.
A 24 Volt a.c. auxiliary output option is also available.
The drx 400dc receiver is normally supplied in an IP67 weatherproof enclosure and is designated
drx 400dc WBX. On installation it will be necessary to make suitable holes in this enclosure to
facilitate cable entry and exit. Adequately rated cable or flexible conduit glands should be used at
all times to avoid he possibility of water ingress.
The drx 400dc receiver can be used with the dtx 400pj single channel telemetry transmitter or any
of the following multi-channel telemetry transmitters, providing they are fitted with the optional
proportional joystick ( /jp )
dtx 1000/8, dtx 1000/16, dtx 1000/8AL, dtx 1000/16AL The slave keyboard dtx 1000K can also be
used providing it is fitted with the joystick option.

TECHNICAL SPECIFICATION

Power Requirements:
Input 230 Volts 50Hz
Maximum Load:
5 A at 230 Volts 50 Hz
Fuses:
Auxiliary (F1): 5A. T
Receiver (F2): 630mA. T
Outputs:
230 Volts 50Hz
3 off single pole changeover relays with suppression fitted:
1.Wash 2.Wipe
1 off un-switched
24 Volts d.c.
1.Tilt Motor x 2
12 Volts d.c.
1.Camera 2.Zoom, Focus & Lens Ground
Other
RS 232 or 485 & Twisted Pair
drx 400d.c. Installation Manual
3.Illuminators
2.Tilt Brake x 2 3.Pan Motor x 2
3.Auto-Iris Over-ride Voltage & Return
4.Pan Brake x 2
Page. 3