Settings For Normal Operation - Dedicated Micros drx 400 Manual De Instalación

Switch 8 ON
Switch 3 ON then OFF
Switch 8 OFF
FOR A FULLER EXPLANATION SEE SETTINGS FOR NORMAL OPERATION. BELOW
f. Activate Lens Fine Response
Switch 8 ON
Switch 7 OFF and ON
Switch 8 OFF
Switch 7 OFF
N.B. For a new unit this step should be omitted if lens fine response mode is not to be used. However, for a previously programmed unit, in order to revert to the
default setting the following steps should be carried out.
Switch 8 ON
Switch 7 ON and OFF
Switch 8 OFF
Once all of the programmes settings are complete, the DIP switches can be set for their desired normal operation modes. This is achieved with DIP switch 8 in the
OFF position
FOR A FULLER EXPLANATION SEE SETTINGS FOR NORMAL OPERATION. BELOW

SETTINGS FOR NORMAL OPERATION

Several functions have more than one setting available for normal operation. These settings can
only be made when all of the programme settings have been carried out and Programming Mode
has been exited.
The DIP switches control the following functions when not in programming mode:
SWITCH
SWITCH 1
SWITCH 2
SWITCH 3
SWITCH 4
SWITCH 5
SWITCH 6
SWITCH 7
SWITCH 8
drx 400d.c. Installation Manual
Switching ON and OFF activates a Self Test sequence
Reverses the zoom motor direction ON = Reversed
Reverses the focus motor direction ON = Reversed
Selects the Iris-Override voltage range
OFF = 2.5 to 12 Volts d.c. ON = 2.5 to 5.5 Volts d.c.
See table page 14
See table page 14
Activates the Datum option ON = Datum Activated
OFF = position selects Normal Operating Mode
Enters the Programme Mode
Returns the unit to the default setting
(patrol always mode = OFF)
Exits Programming Mode
Enters the Programme Mode
Activates the lens fine response mod
(anti-hunting mode for lenses with
sluggish response)
Exits Programming Mode
Returns the unit to the default setting
Enters the Programme Mode
Returns the unit to the default setting
Exits Programming
FUNCTION
Page. 13