Suzuki GD115 Manual Del Propietário página 86

GD115 99011-36H51-01D
Tires
• Inflate the tires to the pressure recommended in this
manual.
Exterior
• Spray all rubber parts with a rubber protective agent.
• Spray all paint-free surfaces with an anti-rust agent.
• Coat the paint surface with vehicle wax.
Procedures for motorcycle re-service
• Clean the motorcycle completely.
• Re-install the battery.
NOTE: Connect the wire to the positive terminal first;
then the negative terminal. Remove the spark plug. Start
the engine several times, and then mount the spark plug.
• Adjust tire pressure according to the instructions in the
tire section.
• Lubricate according to
lubrication section.
• Be sure to conduct necessary inspections according to
this manual before riding.
NOTICE OF BATTERY USAGE
1. ACTIVATION OF NEW BATTERY
1.1 Addition electrolyte
1.1.1 Check the appearance of the battery and make
sure there are no scratches and cracks, the terminals
should not be slanting or deformed.
1.1.2 Take off the sealed rubber cap of the air outlet,
take off the vent plug.
V01 Export ENG
the instructions in the
2014-08-11
1.1.3 Take out the special battery electrolyte provided
with the battery, cut off the electrolyte container cap, put
a plastic tube to fill electrolyte slowly, till the liquid level
reached the upper level, put it aside for 20 minutes after
adding electrolyte. If the liquid level drops, replenish till
the upper level.
NOTE: Please do not exceed the upper level mark.
1.1.4 Thirty minutes after adding electrolyte, the engine
can be started. If conditions permit, recharge for 3-5
hours before riding, which will further improve startup
performance and extend the battery life. In winter when
the temperature is low or after long periods of storage,
the battery should be recharged for 3-5 hours before
using.
1.1.5 Close the filling hole plug tightly, rinse away any
electrolyte outside the battery with clean water, use cloth
to wipe it clean.
1.2 Installation
1.2.1 Put the air outlet onto the nozzle, make sure that
the pipe is not distorted or crushed, otherwise the
battery might explode. If any electrolyte is spilt out,
corrosion may occur to both your clothes and the
motorcycle.
1.2.2 First connect the positive (+) terminal (red wire),
then connect negative (-) terminal, Note: please note
that reversing the wires can damage the electric
components such as the igniter device and the rectifier.
1.2.3 After tightening the bolt, apply grease or jelly on
the bolt, nut and terminal, so as to avoid poor connection
caused by rust.
37