Carburetor; Fuel Filter - Suzuki GD115 Manual Del Propietário

GD115 99011-36H51-01D
insufficient, adjust it with the method below.
1. Remove the rubber bush 4 along the clutch cable,
loosen the nut 2 and dismantle the protective shell 1.
2. Turn the adjusting screw clockwise 3 till the end.
3. Loosen the lock nut 6, adjust the screw 7 along the
front-back direction, operate the clutch handle and
adjust the clutch cable gap 5 to be about 4 mm.
4. Do fine adjustment through the adjusting screw 3.
5. Firmly lock the nut 6, reinstall the protective shell 1
and firmly lock the nut 2 and then mount the rubber
bush 4.
NOTE: Excessive clutch cable play can easily result in
wear and faults in the clutch and the gear shift lever.

CARBURETOR

Stable carbureting evaporation is the most fundamental
requirement for the carburetor.
evaporation has been accurately set in the factory.
Please do not change its setup. You only need to pay
attention to two things: idle and throttle cable free-play.
Adjustment of Idle speed
1. Start the engine, keep it running
at idle till fully pre-heated.
2. After the engine has been pre-
heated, release the throttle, turn
the adjusting screw to right and
left to keep the engine revolving
speed between 1400-1600 rpm.
V01 Export ENG 2014-08-11
The carbureting
CAUTION
Adjustment the engine idle speed should be done
when the engine has been fully pre-heated.
THROTTLE CABLE PLAY
To adjust the cable play:
1. Loosen lock nut 1.
2. Turn the adjuster 2 so that the
throttle cable has 0.5-1.0mm
play.
3. Tighten the lock nut 1.
WARNING
Inadequate throttle cable play can cause engine
speed to rise suddenly when you turn the
handlebar. This can lead to loss of rider control.
Adjust the throttle cable play so that engine idle
speed does not rise due to handlebar movement.

FUEL FILTER

1 Filter bowl 2 Filter element 3 Seal ring
(A) Compressed air
The fuel filter is in the fuel cock below the fuel tank. Its
29
0.5-1.0mm