Husqvarna TE125 2011 Caracteristicas - Uso - Mantenimiento página 58

CLUTCH CONTROL
The clutch lever (1) is located on the left-hand side of the
handlebar and is protected against dirt.
The clutch control position on the handlebar can be ad-
justed by loosening the lower retaining screw (A).
CAUTION*
Do not forget to tighten the screw after
the adjustment.
1
REAR BRAKE CONTROL
The rear brake control (1) is placed on the right-hand
side of the motorcycle. On models TE and SMR a stop
switch, during the braking action, causes the stop light
on the tail light to come on.
A
GEAR SHIFT CONTROL
The lever (1) is placed on the left-hand side of the en-
gine. The operator must release the lever after each gear
change to allow it to return to its central position. Neutral
position (N) is between the first and second gears.
First gear is engaged by pushing the lever downwards;
for other gears push it upwards.
The position of the gear shift lever on the shaft can be
varied as follows: loosen the screw, pull the lever out,
and place the lever in a new position on the shaft.
Tighten the screw once operation is completed.
CAUTION*: Do not shift gears without
disengaging the clutch and closing the
throttle. The engine could be damaged
by overspeed.
WARNING*: Do not downshift when
travelling at a speed that would force
the engine to overrev in the next lower
gear, or cause the rear wheel to lose
grip.
6
5
1
4
3
2
N
1
1
EN - 15