Tips And Recommendations Questions About The Telis 6 Chronis Rts - SOMFY Telis 6 Chronis RTS Manual Del Usuario

7.2.3. Simulated presence function
In automatic mode, the "Simulated presence" function randomly changes the times at which the
programmed automatic orders are triggered, within a range of 0 to 30 minutes. This function is
specially recommended to simulate your presence when you are away from home for an extended
period of time.
To activate the function:
1) Make sure that the Telis 6 Chronis RTS is in automatic mode (if it is in manual mode, briefly press
the selection button ( ) to switch to automatic mode).
2) Press both arrow buttons ( and ) simultaneously:
the ( ) symbol appears on the screen: the "Simulated
presence" function is activated.
To deactivate the function:
- Press both arrow buttons ( and ) simultaneously: the
( ) symbol disappears from the screen: the "Simulated
presence" function is deactivated.
- Or switch to manual mode.
Switching to manual mode automatically deactivates the "Simulated presence" function. The
function must be reactivated, if required, when returning to automatic mode.
7.2.4. Modifying the general parameters of the remote control transmitter
The general parameters of the remote control transmitter can only be modified in automatic
mode.
1) Make sure that the Telis 6 Chronis RTS is in automatic mode (if it is in manual mode, briefly press
the selection button ( ) to switch to automatic mode).
2) Press and hold the selection button (f) until "SET" and "YEAR" appear on the screen (> 7 s):
"Remote control settings" mode is activated. The year flashes: this is the first parameter to be set.
3) Follow the procedure in the "
section.
4) Once the last parameter has been confirmed, "Remote control settings" mode is deactivated, and
the Telis 6 Chronis RTS returns to automatic mode.
"Remote control settings" mode can be deactivated at any time by pressing and holding the
selection button (f). Only confirmed parameters are saved.
8. Tips and recommendations
Questions about the Telis 6 Chronis RTS?
Observations
The end-products on the
selected channel do not
react at all when a button
on the Telis 6 Chronis
RTS is pressed.
Copyright © 2010 Somfy SAS. All rights reserved.
Setting the general parameters of the remote control transmitter"
Possible causes
The batteries are low.
The end-product(s) is(are) not on
the selected channel.
The remote control transmitter is
not programmed.
External radio equipment is
interfering with the radio reception.
The remote control transmitter is in
automatic mode.
The motor(s) or receiver(s) are in
thermal cut-out mode.
Solutions
Replace the batteries.
Select the corresponding channel or add the
motor or receiver to the channel.
See the "Adding/Deleting a telis 6 Chronis RTS"
section.
Turn off any radio appliances nearby.
Briefly press the selection button to switch to
manual mode.
Wait for the motor to cool down, then press the
desired button again.
Telis 6 Chronis RTS
11