Using An External Subwoofer - Yamaha YSP-1400 Manual De Instrucciones

2
While the test-tone is output from the channel to be adjusted, press
the SUBWOOFER key (+ or –) to balance the volume level with the
other channels.
During volume adjustment, the cycle of the test tone stops. When you have finished
adjusting the current channel level, release the + or – key and wait a moment for
the test-tone cycle to resume. You can check the volume level by the indicator
lights.
3
After adjustment is complete, press the CH LEVEL key again.
The test-tone stops.
HINT
• Press the VOLUME key (+ or –) to adjust the overall volume while the test-tone is being played back.
• When the YSP position setting is changed (p.9), the channel level setting will be overwritten.
16

Using an external subwoofer

The unit has dual built-in subwoofers; however you can connect an external subwoofer
when you want to enhance low frequency sound. Perform the following steps to change
the setting when using an external subwoofer.
1
Connect the unit to the external subwoofer with a pin cable.
2
With the unit turned off, hold down the SUBWOOFER (-) key on the
supplied remote control for more than 5 seconds.
The unit turns on and the external subwoofer is selected.
You can check the status of the subwoofer setting by the indicator when turning on
the unit.
Off (external subwoofer), lights up (built-in subwoofer)
To select the built-in subwoofers again, hold down the SUBWOOFER (+) key of the
remote control for more than 5 seconds.
NOTE
• The default output setting is for the built-in subwoofers.
• Use an external subwoofer with built-in amplifier.
Mono input