Accessory Installation; Configuration - WEG CFW500 Guía De Instalación, Configuración Y Operación

Analog and Digital I/O Plug-in Module

4 ACCESSORY INSTALLATION

The accessory is easily installed or replaced. For correct
installation of the accessory perform the following steps:
Step 1: With the converter de-energized, remove the
front cover of the inverter as shown in figure A.1 (a).
Step 2: Remove, if there is one, the accessor y
(connected plug-in module) according to figure A.1 (a).
Step 3: Fit and press the accessory to be installed as
shown in Figure A.1 (b) and then connect the front cover.
Step 4: Energize the inverter and check if the parameter
P0027 indicates the value 3 (P0027 =3). If this information
is not true, check that the module used is actually the
CFW500-IOAD and repeat steps 1-4.

5 CONFIGURATION

The control connections (analog input / output, digital
inputs / outputs and RS485 interface) must be made to
the connector as shown in figure 1.
GND
+24 V
6 | CFW500