Wittur Eco BUS Manual De Instrucciones página 20

3411.32.0100 ed.0
GB
Pag.18.78
8 If the motor is running in wrong direction the electronics rectifies the motor rotation direction
when the "Ref Switch" is closed and a new learning procedure will re-start.
Is no reference switch available the direction of the motor rotation has to be changed by crossing
the motor cables, if necessary (Press the LEARN button again).
9 Now the learning of door width is done during 2 consecutive full door width movement cycles
(STATE LED off --> learning done).
Take care, that the commands are available in end position for more than one second, that the elec-
tronic has time enough to detect the mechanical end position.
10 The parameters are stored automatically after learning procedure.
11.4 DRIVING THE DOORS WITH THE ELEVATOR CONTROLLER
- Connect the signals from the elevator controller to connector X1 and
X2 of the door operator.
- Refer to the project delivery documents for the wiring diagram
between the elevator controller and door operator (see also circuit dia-
gram in chapter 17).
- Check if Test Button operation Switch is OFF S1/1.
- If the door is not at the reference switch (near by close end) in power up and CLOSE is active (con-
nected with COMMON) it will move at low speed as long as the reference (close end) position is
found.
- After finding the reference switch the door drive will start with the next OPEN command in direc-
tion open with normal speed drive until the mechanical end is found.
- Then the door will drive with normal speed in both directions.
- Check that the safety devices (open button, photo cells and close force limiter) reopen the door (see
DIP-switch description).
- According to the DIP-Switch adjustment (S1/2) the door is reopend by the elevator control or auto-
matically by the door.
11.5 DRIVING THE DOORS BY THE SERVICE DRIVE BUTTONS
- The Test Buttons only work when the Test button operation switch (S1/1) is active.
- Check that the door is moving open and close when the test buttons are pressed.
- In this mode of operation the re-opening of the door by a safety device is not activated (enables the
adjustment of the closing force).
Sujeto a cambios sin previo aviso
EXCELLENCE IN COMPONENTS
Subject to change without notice!