MO-EL GIROSOLE 769 Manual Del Usuario página 9

10. If the power supply cord is damaged, avoid to use the appliance.
For power cord replacing, please contact the manufacturer or the
technical service or a person with similar qualification, in order to
avoid any risk.
11. If the appliance is not used for a long period, disconnect it from
the power supply.
12. The heaters are fitted with safety guards. These are intended only
to stop large objects from hitting the emitters. On no account
should the heater be operated with the guard removed.
2. INSTALLATION (MOD. 769 AND 769S)
Installation should always be carried out by a qualified electrician or
a competent person in accordance with the standards that regulate
the electrical systems. The energy supply must be done through a
properly grounded socket. The sets have to be connected to the main by
skilled personnel, using a duly dimensioned silicon rubber cable H07RN-F .
The product is in class I and IP65, wich is the protection rate for the
units to be used even outdoor. For keeping the protection rate of the
appliance, the connection of the appliance with the power supply
must be done by means of a minimum IP65 system, as per the effec-
tive regulations in each country.
An overvoltage category III omnipolar circuit breaker with con-
tact opening distance of at least 3 mm must be fitted upstream
from the supply line.
Ensure that the supply cable is well mounted and that it does not
come into contact with the reflector of the heater or that it does not
trail into the heated area.
Sequence
1. Unscrew the 9 screws of the cover that have the data label (fig. 4).
2. The set is already arranged to be connected to the main both by
single phase and three phase connection (3 phase + neutral +
ground):
To carry out a single phase connection, connect the phase leads,
•
neutral and ground to the poles of the terminal as respectively
marked L1-N- (fig. 7). Use a cable H07RN-F 3x2.5 mm
9
.
2