WEG CFW500 Guía De Instalación, Configuración Y Operación página 8

Installation, Configuration and Operation Guide
Table 1: Settings of switches to select the type of analog input and output of the CFW500-CUSB
Input / Output Signal
Voltage
AI1
Current
Voltage
AO1
Current
Table 2: Settings of switches for configuration of the RS485 and USB in the CFW500-CUSB
Communication Switch
RS485
USB
S2
(*) Any other combination of switches is not allowed.
The USB communication of this module presents the following features:
Interface with the computer: USB V2.0 Plug and Play.
„
Plug-in mini USB connector (mini-B – see figure A.2).
„
Firmware recording of the main processor via FDT (available on the CD-ROM). With
„
the de-energized inverter, the DIP-switch S2 must be set as in table 2.
Parameter setting and programming of the SoftPLC (WLP program). The indications
„
of alarms, faults and communication status is done through HMI and product
parameters. For more details see the manual of the softPLC.
Superdrive.
„
ATTENTION!
With the switches S2.1=ON and S2.2=ON the inverter is putting on the
firmware recording mode. This operation should only be done with WEG's
agreement. Improper use of this operation may damage the inverter.
8 | CFW500-CUSB
Setting of switch S1
S1.1 = OFF
S1.1 = ON
S1.2 = ON
S1.2 = OFF
Setting of switches
S1.3 = OFF and S1.4 = OFF Termination RS485 OFF
(*)
S1
S1.3 = ON and S1.4 = ON Termination RS485 ON
S2.1 = OFF and S2.2 = OFF USB in normal communication mode
(*)
S2.1 = ON and S2.2 = ON USB in firmware recording mode
Range of signal Parameter settings
0...10 V
0...20 mA
4...20 mA
0...10 V
0...20 mA
4...20 mA
- English -
P0233 = 0 or 2
P0233 = 0 or 2
P0233 = 1 or 3
P0253 = 0 or 3
P0253 = 1 or 4
P0253 = 2 or 5
Option