Operating Instructions; Setup And Commissioning; Benchtop Unit; Wall Mounting - Renfert SYMPRESS Serie Instrucciones Para El Servicio

Before opening the unit, disconnect it from
the mains power supply by unplugging the
power cord from the wall outlet.
The unit complies with current EU direc-
tives (see section H).
Other symbols are explained as they occur.
1. Setup and
Commissioning
The SYMPRESS can be used as a benchtop unit, alt-
hough it is also suitable for wall mounting.

1.1 Benchtop Unit

Select a stable underlay on which to set the unit up.

1.2 Wall Mounting

With the aid of the wall mounting kit (refer to the ac-
cessories), the SYMPRESS can be securely mounted
on a wall.
The mounting instructions are included in the mounting kit.

1.3 Setup Recommendations

Operate the unit at room temperature 18 - 24ºC [64 – 75.2ºF].
When setting up the unit, please note the following:
• Do not place the unit under a heat source.
• Do not place the unit in front of open windows.
• Do not set the unit up where it will be subjected to direct sunlight.
• Do not subject the unit to high humidity.

1.4 Connection and Starting

Before connecting the unit to the wall out-
let, make sure the voltage information on
the nameplate corresponds to your local
power supply.
• Connect the provided power cord to the mains con-
nection socket (Fig. 1).
• Plug the power cord into the wall outlet.
• Switch the unit on at the main power switch
(A, Fig. 2).

1.5 Shipping Restraint

The shipping restraint must be removed before the unit
may be operated:
• The unit has been connected and switched on as
described in Section 1.4.
• Close the unit cover.
EN

Operating Instructions

• Press the retract key (F, Fig. 3): • Press the retract key (F, Fig. 3):
- The pistons retract to their home position where
they stop.
• Open the unit cover.
• Remove the shipping restraint (Fig. 4).
The unit is now ready for use.

2. Operation

2.1 Operating Elements

See fi g. 2 and 3.
(A) ON / OFF switch
(B) Device fuse
(C) Fill level indicator
(D) "Impression tray" advance key (fast)
(E) "Dispenser" advance key (slow)
(F) Retract key
(G) Green LED, unit ON
(H) Red LED, unit cover
(I) Yellow LED, remaining amount
2.2 Cartridge Installation and
Replacement
A cartridge can only be installed or replaced if both
pistons are in their home position (Fig. 5).
1. Close the unit cover and retract the pistons.
The pistons return to their home position at high speed
and automatically stop.
- 2 -
(F, Fig. 3)