Petsafe PCF-1000-20 Manual De Adiestramiento Y Funcionamiento página 13

4. Check the tightness of the Receiver Collar by inserting one
finger between the end of a Contact Point and your cat's neck. The fit should be snug but not constricting (9B).
5. Allow your cat to wear the collar for several minutes then
recheck the fit. Check the fit again as your cat becomes
more comfortable with the Receiver Collar.
6. Trim the collar as follows (9C): a. Mark the desired length of the Receiver Collar with a
pen. Allow for growth if your cat is young or grows a
thick winter coat.
b. Remove the Receiver Collar from your cat and cut off
the excess.
c. Before placing the Receiver Collar back onto your cat, seal
the edge of the cut collar by applying a flame along the
frayed edge.
Important: For comfort, safety and effectiveness of product, please ensure the following:
• During the fi rst 2 weeks of training, do not use the training device on your pet without direct
supervision.
• Check the fi t to prevent excessive pressure by being able to insert one fi nger between the Contact Point
and your pet's skin.
• Your pet must be carefully examined daily for any signs of a rash or sore.
• If a rash or sore is observed, discontinue the use of the Receiver Collar for a few days.
• If the condition persists beyond 48 hours, see your veterinarian.
• Your pet's neck and the Contact Points must be washed weekly with a wash cloth and mild hand soap,
then rinsed thoroughly.
A condition called Pressure Necrosis, which is a de vitalization of the skin due to excessive and
prolonged contact against the Contact Points, may occur if the steps above are not followed.
To Re-Thread the Collar
Slide Buckle
The slide buckle prevents the collar from becoming loose
around your cat's neck.
www.petsafe.net
9B
9C
13