Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Not for use with
router
bits. Use with router
bits
will cause kickback.
1. To attach the 53033 flex-shaft (sold
separately) to the Rotary Tool remove the
housing
cap from the tool as shown in
Figure 1. Then press the shaft lock and
unscrew the collet nut and remove the
collet. Install the driver cap on the motor
shaft as shown in Figure 2 and tighten.
To prevent damage
to
tool, do not overtighten
driver cap. Tighten the driver cap finger
tight and then tighten an additional
1/3 turn
with the wrench.
(Wrench included
with your
Rotary Tool kit).
2. Screw the flexible shaft onto the Rotary
Tool housing
being sure that the square
end of the center core engages the square
hole socket in the driver cap Figure 3.
Do not pull out center
core to engage into driver
cap. This could cause disengagement
of
center core from handpiece.
If tool stops
when shaft is bent, center core may be
lodged in driver cap. Loosen
shaft and
remove core from driver cap. Then screw
flexible shaft onto rotary tool housing again.
Flex-Shaft
Collet Assembly
The collet assembly
consists
of a co!let nut
and collet. To change bits use the wrench
and a bit. Insert the shank portion of any bit
(1/8" shank recommended)
through the
opening in the flex-shaft
hand piece to lock
the shaft. With the shaft secured,
use the
wrench to loosen or tighten the collet nut as
shown in Figure 4. With the collet nut loose,
insert an accessory
or bit as deeply as
possible to avoid wobble during use.
Retighten the collet nut.
Collet
Removal
and Replacement
Four different
size collets to accommodate
different
shank sizes, are available for your
flex-shaft.
To install a different collet, remove
the collet nut and remove the old collet.
Insert the unslotted
end of the collet in the
hole in the end of the flex-shaft.
Replace
collet nut on the shaft. Always
use the
collet
which
matches
the shank size of
the accessory
you plan to use,
Never force a larger diameter shank into a
collet.
Available
Collets
No. 53065
Collet
Nut Kit -Includes
one
1/8", 1/16", 1/32" & 3/32" collets and collet
nut.
Flexible Shaft Lubrication
The flexible shaft should be lubricated
after
every 25-30 hours of use. To lubricate,
unscrew the flexible shaft assembly from the
motor housing.
Pull the center core out of
the flexible shaft assembly.
Wipe a very thin
film of a good quality, high temperature
grease on to the center core.
To prevent
damage
to
tool do not over grease
shaft. Too much grease will cause the unit
to overheat.
Automotive
wheel bearing
grease should be used.
Reattach the flex-shaft
to the rotary tool.
I
HOUSING
CAP
COLLET
/
/
(insid__
DRIVER MOTOR
CAP
SHAFT
FLEXIBLE
SHAFT
/
COLLET (inside)
COLLET
(,I
NUT
_]
8IT
16
Tabla de contenido
