Intended Use; Assembly And Adjustments - Craftsman CMEW400 Manual De Instrucciones

...................... earthing terminal
..................... safety alert symbol
..................... visible radiation
..................... wear respiratory
protection
..................... wear eye
protection
..................... wear hearing
protection
..................... read all
documentation
../min or ..min . Revolutions or
-1
Reciprocations per
minute
2 .................. two phase
alternating current
SAVE THESE INSTRUCTIONS FOR
FUTURE USE
COMPONENTS (FIG. A)
Motor
Be sure your power supply agrees with the nameplate
marking. Voltage decrease of more than 10% will cause loss
of power and overheating. Your tool is factory tested; if this
tool does not operate, check power supply.

Intended Use

This oscillating multi-tool is designed for professional detail
sanding, plunge cutting, flush cutting, removal of excess
materials and surface preparation applications.
DO nOT use under wet conditions or in presence of
flammable liquids or gases.
This oscillating multi-tool is a professional power tool.
DO nOT let children come into contact with the tool.
Supervision is required when inexperienced operators use
this tool.

ASSEMBLY AND ADJUSTMENTS


WARNING: To reduce the risk of serious personal
injury, turn unit off and disconnect it from
power source before making any adjustments or
removing/installing attachments or accessories.
An accidental start-up can cause injury.

WARNING: Risk of lacerations or burns. Do not touch
the sharp edges of accessories at any time. Do not
touch work piece or blade immediately after operating
the tool. They can become very hot. Handle carefully.
Always allow accessories and work piece to cool
before handling.
Installing/Removing Accessories (Fig. B–D)
The tool features an exclusive Tool-Free System for faster
accessory changes and adjustments without the need for
wrenches or hex keys like other oscillating tool systems.
2N ............... two phase
alternating current
with neutral
3 .................. three phase
alternating current
3N ............... three phase
alternating current
with neutral
.................. rated current of the
x
appropriate fuse-
link in amperes
............ time-log miniature
A
fuse-link where X
is the symbol for
the time/current
characteristic, as
given in
IEC 60127-3
IPXX .................... IP symbol
1. Grasp the tool and squeeze the Tool-Free accessory
clamp's 4 lever.
2. Clean any residual debris from the tool shaft
Tool-Free accessory clamp holder.
3. Slide the accessory between the shaft and the accessory
holder making sure the accessory engages all of the pins
8 on the holder and is flush with the shaft as shown in
Figure B.
4. Release the Tool-Free accessory clamp lever.
5. Some accessories, such as scrapers and blades can be
mounted at an angle if required as shown in Figures C
and D.
Fig. B
8
4
Fig. C
Fig. D
English
7 and the
7
5