Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Fig. C
GROUNDED OUTLET BOX
GROUNDING MEANS
ADAPTER
nOTE: In Canada, the use of a temporary adapter is not
permitted by the Canadian Electric Code.
DANGER: In all cases, make certain that the
receptacle in question is properly grounded. If
you are not sure, have a qualified electrician
check the receptacle.
SAVE THESE INSTRUCTIONS FOR
FUTURE USE
COMPONENTS (FIG. A)
Motor
Be sure your power supply agrees with the nameplate
marking. Voltage decrease of more than 10% will cause loss
of power and overheating. These tools are factory tested; if
this tool does not operate, check power supply.
Intended Use
The CMEW020 is a 6" (152 mm), variable-speed bench
jointer intended for jointing and planing wood with a
designed cutting capacity of 6" (152 mm) wide and 1/8"
(3 mm) deep. Unit includes a 10 Amp, 120 Volt motor with
a variable speed range of 6000 to 11000 RPM, and a cutting
speed range of 12000 to 22000 CPM, a dust chute, a center-
mounted fence, a two-knife cutterhead, a cutterhead guard
and lock, wrenches, and push blocks.
DO nOT use under wet conditions or in presence of
flammable liquids or gases.
DO nOT let children come into contact with the tool.
Supervision is required when inexperienced operators use
this tool.
ASSEMBLY AND ADJUSTMENTS
WARNING: To reduce the risk of serious personal
injury, turn unit off and disconnect it from
power source before making any adjustments or
removing/installing attachments or accessories.
An accidental start-up can cause injury.
Unpacking and Cleaning
Carefully unpack the machine and all loose items from the
shipping container(s). Remove the rust-preventative oil
from unpainted surfaces using a soft cloth moistened with
mineral spirits, paint thinner or denatured alcohol.
NOTICE: Do not use highly volatile solvents such as
gasoline, naphtha, acetone or lacquer thinner for
cleaning your machine.
After cleaning, cover the unpainted surfaces with a good
quality household floor paste wax.
Assembly Tools Required
Two hex wrenches (supplied)
Assembly Time Estimate
Assembly for this machine takes approximately 1 hour.
Fence (Fig. D–J)
1. Assemble the fence mounting bracket
jointer base using the four M6 x 1 mm x 16 mm button
head screws
12
.
Fig. D
12
2. Assemble the fence sliding bracket
mounting bracket
11
using the lockhandle
washer
13
and special nut
Fig. E
English
11
to the
12
11
3
to fence
19
, M8 flat
14
.
14
5
Tabla de contenido
