Causes And Rectification Of Faults - Caso MCDG 25 Master Manual De Instrucciones

►

15.3 Causes and rectification of faults

The following table assists in localizing and rectifying minor faults.
Error
The selected program will
not start.
The turntable turns jerkily.
Food is not sufficiently
defrosted, warmed up or
cooked after preset time
has elapsed.
The device functions but
the cooking chamber
lighting does not work.
Abnormal noises can be
heard during operation of
microwave.
The time in the display
field is not correct.
►
caso MCDG 25 Master
The device has detected an error on a sensor and has
terminated the current programme.
Press the Stop button to acknowledge this fault.
Please note
If error messages continue to appear after an extended waiting
period and restarting the device, then the device will need to be sent
to Customer Service to be inspected.
Possible cause
Device door is not closed
Power plug is not
plugged in
Fuse is not activated
Dirt between the
turntable and the base of
cooking camber
Dirt on rolling ring
Cooking vessel too large
Incorrectly selected time
or power level
Defective cooking
chamber light.
Food is covered with
aluminium foil
The cookware contains
metal and sparks are
being created within the
cooking chamber
Power failure
Attention
If you are unable to solve the problem with the steps shown above,
please contact Customer Service.
Action
Close device door
Plug in mains plug!
Activate fuse
Remove dirt
Use different cooking vessel
Re-set time and power level
Repeat process
Have Service dept repair cooking
chamber light.
Remove aluminium foil
Observe information on
cookware!
Re-set time
72