Powers Fasteners TRAK-IT TOOL C3 Manual Del Operador página 9

9
12. NEVER ATTEMPT TO OPERATE THE TRAK-IT TOOL IF PARTS ARE LOOSE,
DAMAGED, OR MISSING. Make sure all screws and nuts are properly tightened and all
parts are properly installed and in good working order. If parts are missing, don't attempt to
make temporary repairs...contact your Customer Service Representative immediately.
13. NEVER DRIVE FASTENERS ON TOP OF OTHER FASTENERS OR TOO CLOSE TO
OTHER FASTENERS. Fastening on top of or too close to other fasteners can cause the
fastener to ricochet and cause serious injury. Fasten only in areas where the entire shank
can penetrate. Fastener spacing should be a minimum of 3" (76 mm).
14. NEVER FIRE INTO VERY HARD OR BRITTLE MATERIALS SUCH AS CAST IRON,
TILE, GLASS, OR ROCK. These materials can shatter, causing sharp fragments and/or
the fastener to fly freely
15. NEVER CARRY FASTENERS OR OTHER HARD OBJECTS IN THE SAME POCKET
OR CONTAINER WITH FUEL CELL. The Fuel Cell could be punctured, causing serious
injury.
16. NEVER ALLOW ANYONE TO USE THE TRAK-IT TOOL UNLESS THEY READ AND
UNDERSTAND THE TOOL MANUAL AND ALL SAFETY INSTRUCTIONS. It is the
tool owner's responsibility to make sure that all Trak-It tool users read and fully understand
all tool operation, safety and maintenance instructions.
17. FUEL CELL STORAGE. Fuel Cells contain flammable gases which are under pressure
and, must be stored in an area where they will not be exposed to direct sunlight an open
flame, sparks, or temperatures above 120° Fahrenheit (49° Celcius). Exposure to
temperatures above 120°F (49°C) may cause the Fuel Cells to leak or burst, releasing the
flammable gases and creating a risk of fire or explosion.
18. FUEL CELL DISPOSAL. Never attempt to puncture, crush, burn or refill a Fuel Cell.
Always dispose of empty Cells with trash that will not be burned. Also, never place the Fuel
Cell with other materials for reclamation or recycling.
19. TOOL STORAGE. At the end of every workday, remove the Battery Cell and store both the
tool and battery in the carrying case.
20. KEEP THE TOOL CLEAN. At the end of each work day, take a minute to wipe the Trak-It
tool with a clean rag. A dirty tool is more likely to jam or malfunction.
21. NEVER PLACE YOUR HAND OR FINGERS OVER THE NOSE OF THE TOOL. The
fastener or piston can seriously injure your hand in the event of an accidental discharge.
TRAK-IT TOOL MODEL C3, C3 ST
9