Powers Fasteners TRAK-IT TOOL C3 Manual Del Operador página 18

If you find that the Trak-It tool fan does not operate after clearing a jam:
Check the condition of your Battery Cell.
END-OF-WORKDAY ROUTINE
At the end of each workday, conduct an end-of- workday routine. These simple steps are
based on maintaining the safety and operational efficiency of the Trak-It tool.
Before you leave the work-site:
1. Remove the Battery and store in the tool case if fully or partially charged. Always use the
Trak-It tool case for transporting and storing the tool.
2. Dispose of all empty Fuel Cells. Remember to dispose of these cells where they will not
be found by children, crushed, punctured, or burned.
3. If battery is low, place the Battery Cell in its Charger.
4. Wipe your Trak-It tool with a clean, soft cloth.
5. Check Contact Arm to ensure it is operating freely.
These simple steps will not only ensure that your Trak-It tool is ready to go to work the
next day, they will also ensure that you get the maximum efficiency from your tool.
TRAK-IT TOOL ACCESSORIES
A variety of accessories are available for the Trak-It tool:
55583 Battery
55618 Trak-It Tool Charger Base
55639 12 Volt Car Adapter
55619 110 Volt Adapter Card
55643 Carring Case
Contact your Powers Fasteners customer service representative for additional information.
TRAK-IT TOOL MODEL C3, C3 ST
18
18