Powers Fasteners TRAK-IT TOOL C3 Manual Del Operador página 6

working direction, the adjustment of mains supply, the workpiece, the workpiece support.
NOTE: EXCEEDING THESE RATES COULD CAUSE THE TOOL TO OVERHEAT,
RESULTING IN LOSS OF PERFORMANCE OR DAMAGE TO TOOL COMPONENTS.
BY USING THE TRAK-IT TOOL AT ITS RECOMMENDED OPERATION RATE YOU WILL BE
ABLE TO DRIVE SEVERAL THOUSAND FASTENERS IN A TYPICAL WORKDAY.
Maximum Fastener Size:
1-1/2 inch (38 mm) long x. 102 inch (2.59 mm) diameter shank
Magazine Capacity:
Battery :
6 volts D.C. (nickel metal hydride) – Provides enough energy to drive approximately 3000
fasteners on a full charge.
Charge time – Approx. 2-1/2 hours.
Fuel Cell:
Liquid hydrocarbon – Provides enough fuel to drive up to 1200 fasteners.
(Dangerous goods class 2.1 UN1075 2.7 fl oz/40g/80ml)
NOTE: POWERS FASTENERS DECLARES THAT THE MODEL TI-C TOOL IS IN
CONFORMANCE WITH THE EUROPEAN "MACHINES" DIRECTIVE.
Air Filter Cover, Air Filter And Cylinder Cap
Motor Assembly
Jam Clear Lever Unit
Nose Piece
Contact Arm
NOTE: The triangle symbol marked as "
safety yoke is equipped with this tool.
TRAK-IT TOOL MODEL C3, C3 ST
TRAK-IT C3
42 fasteners
Actuator
Low Battery Voltage Indicator Light
Handle Assembly
Trigger
Magazine Assembly
Follower
" following its tool serial number indicates that
6
TRAK-IT C3 ST
22 fasteners
Battery
Follower Release
Lever
Magazine Foot
6