Tabla de contenido
Idiomas disponibles
Idiomas disponibles
KEY DIMENSIONS
AND SPECIFICATIONS
Description
Top-Loading
W'asher
Rated Voltage/Frequency
120VAC, 60Hz
Dimensions
27"(W)
X 28 3/8"(D)
X 4t
3/10"(H),
55 1/8"(H
with lid open)
68.6 cm (W) X 72.1 cm (D) X 105.0 cm (H), 140 cm (H with lid open)
Net W'eight
137.3 Ibs. (62.3kg)
CHOOSE THE PROPER LOCATION
• installing on carpeting
and soft tile surfaces is
not recommended.
• Never install the washer on a platform
or weakly
supported
structure.
result in damage to property or serious bodily harm.
CLEARANCES
serious injury,fire, electric shock,or death.
warning can cause seriousinjury, fire, electric shock, or
death.
• To reducethe risk of electricshock, do not instali the
washer in humid spaces.Failureto follow this warning can
cause serious injury,fire, electric shock, or death.
• To ensure properair flow, do not block the large opening
on the bottom of the washer with carpeting or other
materials.
• Do not remove groundprong. Do not usean adapter or
extensioncord.Plug into a grounded3-prongoutlet. Failure
to follow thiswarning can cause serious injury, fire, electric
shock,or death.
NOTE: Installingthe washer in a humidspace, or installing or
storing the washer where it will be exposed to the weather or
freezing temperatures, may result in rust or other damage that
is not covered by the produd warranty.
Power Outlet
• The power outlet must be within 60 in. (1.5m) of either side
of the washer.
• The appliance and outlet must be positioned so that the plug
is easily accessible.
• Do not overload the outlet with more than
one appliance.
• The outlet must be grounded in accordance with current
wiring electric codes and regulations.
• Time-delay fuse or circuit breaker isrecommended.
NOTE: It is the personal responsibility and obligation of the
product owner to have a proper outlet installedby a qualified
servicetechnician.
|
FLOORING
• To minimize noiseand vibration,the washerMUST be
installedon a solidlyconstructed floor. See the NOTE to your
right.
• Allowable slope under the entire washeris a maximum 1 in.
difference from side to side or from front to back.
7
(2,5cm)
(686
cm)
_
(2.5cm)
To ensuresufficient clearance for water lines and airflov,; allow
minimumclearances of at least 1 in. (2.5 cm) at the sides and
4 in.(10 cm) behind the unit. Be sureto allow for wall, door, or
floor moldings that may increasethe required clearances.
32
"
(811 cm)
28 sis"
(72,! cm}
55 _/s'*
(i40 cm)
(with open _id)
3/2"
(9 cm}
Minimum
vertical
space from floor to overhead
shelves, cabinets, ceilings, etc., is 56 in.
NOTE: The washer must be installed on firm flooring
to minimize vibration during the spin cycle. Concrete
flooring
is best, but a wood floor is sumcient, provided
it is built to FHA standards. The washer should not be
installed on rugs or exposed to weather.
Capítulos
Tabla de contenido
