KENMORE ELITE 796.3142 Manual De Uso Y Cuidado página 32

BEFORE CALLING FOR SERVICE (continued)
Water in the washer drains
slowly or not at all, or the
display shows:
! o,_ I
Drain hose is kinked, pinched, or
clogged.
Drain discharge ismore than 96 inches
above bottom of washer.
Make sure the drain hose is free of
clogs, kinks, etc., and is not pinched behind
or under the washer.
Adjust or repair drain. Maximum drain
height is 96 inches(8 ft.)
The display shows:
The display shows:
I uEI
The display shows:
The display shows:
The washer has detected an out of
balance load.
If the ub rebalance (see above) is not
successful, this error will be displayed.
The load is too small.
Heavy articles are mixed with lighter
items.
The load is out of balance.
Control error.
Water level is too high due to a faulty
water valve.
If the washer detects a load that is too
far out of balance to spin, it will dis-
play this code while it is attempting to
rebalance the load. The washer will
add water and try to redistribute the
load automatically. This display is for
your information only, and no action is
required.
The automatic attempt to rebalar_cethe load
was not su_essfuLThe cyde has been paused
to allow the load to be manually adjusted.
Small loads may r_d additional itemsto be
added to allow the washer to balance the
loads.
load may have h_vy itemsloaded with
lig_er items. A hvays try tOwash articlesof
somewhat similar weight to allow _ washer
toevenly distribute tk_ weight of the load for
sp_nntng.
Manually redistribute the load if articles have
become tangled preventing the automatic
distrib_on f_ornworking properly.
Unplug the washer and wait 60 seconds.
Reconnect power and try again. If the error
reappears, call for serwce.
Close the water faucets, unplug the wash-
er, and call for service.
The display shows: The water teveJsensor isnot working Close the water faucets, unplug the wash-
correctly, er, and call for service.
The display shows: A motor error has occurred.
The display shows:
The display shows:
Clutcherror.
Foreign objects, such as coins, pins, clips,
etc.r caught between the wash plate
and the inner basket.
Allow the washer to stand for 30 minutes
and then restart the cycle. If the LE error
code persists, call for service.
Mechanical failure.
Unplug the washer and call for service.
Turn off the washer and then press the
Power button. Press the spin speed button
without selecting a cycle to drain and
S_ihn the load.
en the spin is complete, remove the
clothes and then find and remove any
objects caught in the wash plate.
Always check pockets, etc., before wash-
ing to prevent error codes or damage to
the washer or clothing.
32