FAST ADJUSTMENT (FIG. B)
In the point shown in the figure, fit a bush (a), 35
mm (1,37 in.) diameter (or alternatively a shim in the
same size) and make sure the lower branch (C) of
the chain is slightly taut.
If it is not, proceed as follows:
- on the right side, loosen the locking nut (1) of the
wheel pin;
- loosen the check nuts (2) on both chain stretchers
and work on the screws (3) to achieve the right
tension;
- when the adjustment is over, tighten the check
nuts (2) and the wheel pin nut (1).
When the adjustment is over check the wheel for
alignment.
145 mm (5.7 in.)
a
35 mm (1.37 in.)
Fig. B
c
a
1
3
2
EN - 37