Operation; Main Power Switch; Setting The Cooktop - Thermador MASTERPIECE Serie Manual Del Usuario

Operation

Main power switch

Use the main switch to turn on the electronic circuitry for
the control panel. The cooktop is now ready to use.
Turning the cooktop on
Touch the ON I OFF touch key until the indicator above
the main switch and the temperature level indicators
next to the heating elements turn on.
Turning the cooktop off
Touch the ON I OFF touch key. The indicator above the
ON l OFF key goes out. The cooktop is switched off. The
residual heat indicators will remain on until the elements
have cooled off sufficiently.
Notes
The cooktop switches off automatically when all the
▯
elements have been switched off for more than
20 seconds.
The residual heat indicator remains lit until the
▯
elements have cooled down sufficiently.
displayed next to the corresponding element symbol.

Setting the cooktop

This section will show you how to set the elements. The
table contains details on the heat settings for a variety of
dishes.
Setting the element
Select the desired heat level using the number keys
‹
1 to 9.
Heat level 1 = minimum power
Heat level 9 = maximum power
Each heat setting has an intermediate level. This level is
indicated by . in the element display and is set by
touching the
Touch the
1.
indicators light up.
Within the following 10 seconds set the desired heat
2.
setting using the number keys. To set an intermediate
level touch the
1.
/ is
• œ
Changing the heat level
Select the element and set the desired heat level using
the number keys.
Turning off the element
Select the element and set the heat level to 0. The
element is turned off and the residual heat indicator is
displayed.
Note: The heat is turned on and off to regulate the
temperature of the element; this means that the red glow
below the element is not always visible. When you select
a low heat setting, the element turns off for longer
intervals, while at a higher setting these intervals are very
short. Even at the highest level, the element turns on and
off.
symbol.
@
key for the desired element. The
$
symbol.
@
2.
and _
‹
11