Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Installation
5.
Attach the'Y"
connector to the brass
male end of the small hose.
Screw on the coupling
by hand until it is
seated on the connector.
6,
Using pliers, tighten the coupling with
an additional
two-thirds
turn.
NOTE
Do not overtighten,
as it may damage the
coupling.
7.
Attach the angled end of water hoses
(C) to the fill valve at the bottom of the
dryer rear frame. Screw on the coupling
by hand until it is seated on the fill valve
connector.
8,
Using pliers, tighten the coupling with
an additional
two-thirds
turn.
NOTE
Do not overtighten,
as it may damage the
coupling.
9.
Turn the cold water faucet on.
10. Check for leaks around the "Y" connector,
faucets and hoses.
Final installation
check list
•
The dryer is plugged into an electrical
outlet and grounded
properly.
•
The exhaust ductwork
is hooked up and the joints are taped.
•
You have used rigid or stiff-walled
flexible
metal duct material,
not plastic flexible duct.
•
The dryer is level and is sitting firmly
on the floor.
•
For gas models: The gas is turned on and there are no gas leaks.
•
Start your dryer to confirm that it runs, heats, and shuts off.
28
English
Capítulos
Tabla de contenido
