Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Installation
Commonwealth
of Massachusetts
installation
instructions
Your dryer must be installed by a licensed plumber or gas fitter. A"T" handle manual gas
valve must be installed in the gas supply line to your dryer. If a flexible gas connector is used
to install your dryer, the connector can be no longer than 3' (36").
/_
WARNING
•
Gas leaks may occur in your system, creating a dangerous
situation.
•
Gas leaks may not be detected by smell alone.
•
Gas suppliers
recommend you purchase and install a Ubapproved
gas detector.
•
Install and use in accordance with the manufacturer's
instructions.
Electrical requirements
NOTE
The wiring diagram
is located on the plate below the control panel or frame back.
//_ WARNING
•
Improperly
connecting
the equipment
grounding
conductor
can result in a risk of electric
shock.
Check with a qualified
electrician
or serviceman
if you are in doubt as to whether your
dryer is properly
grounded.
Do not modify the plug provided
with your dryer-
if it
doesn't fit the outlet, have a proper outlet installed by a qualified
electrician.
•
To prevent unnecessary risk of fire, electrical
shock, or personal injury, all wiring
and
grounding
must be done in accordance with local codes, or in the absence of local codes,
with the National Electrical Code, ANSI/NFPA No. 70-Latest
Revision (for the U.S.) or the
Canadian Electrical Code CSA C22.1 - Latest Revisions and local codes and ordinances.
It
is your responsibility
to provide adequate electrical services for your dryer.
•
All gas installations
must be done in accordance with the national Fuel Code ANSI/Z223!
- Latest Revision (for the U.S.) or CAN/CGA - B!49
Installation
Codes - Latest Revision
(for Canada) and local codes and ordinances.
18
English
Capítulos
Tabla de contenido
