User Instructions; Installation; Use - Fulgor Milano FCH 905 ID TS G DWK Instrucciones Para La Instalación Y Uso

User instructions

Installation

All the operations concerned with the installation (electrical and gas connections, adaptation
to type of gas, necessary adjustments, etc.) must be carried out by qualified technicians,
in terms with the standards in force. For specific instructions, kindly read the part reserved
for the installation technician.
GB
DO NOT FOCUS INENSEL ON THE LEDS AND DISPLAYS.

Use

Use Gas burners
The ignition of the gas burner is carried out by putting a small flame to the upper part holes
of the burner, pressing and rotating the corresponding knob in an anti-clockwise manner,
until the maximum position has coincided with the marker. When the gas burner has been
turned on, adjust the flame according to need. The minimum position is found at the end of
the anti-clockwise rotation direction.
For models with automatic/ simultaneous (with one hand) ignition, it is sufficient to proceed
as described above using the corresponding knob. The electric spark between the ignition
plug and the burner provides the ignition of the burner itself. After ignition, immediately
release the push-button and adjust the flame according to need. For models with a
thermoelectric safety system, the burner is ignited as in the various cases described above,
keeping the knob fully pressed on the maximum position for approximately 3/5 seconds.
After releasing the knob, make sure the burner is actually lit.
N.B.
- We recommend the use of pots and pans with a diameter matching that of the burner,
thus preventing the flame from escaping from the bottom part and surrounding the pot;
- do not leave any empty pots or pans on the fire;
- do not use any tools for grill-cooking on Crystal hobs.
When cooking is finished, it is also a good norm to close the main gas pipe tap and/or
cylinder.
DWK models
Models SH 905 ID G DWK and SH 905 ID G DWK have a Dual Wok burner. The centre flame
(F1) can be lit by pressing the knob and turning it clockwise or the entire burner (F2) can
be lit as shown in the figure below.
F1
F2
F2
F2
34
F1
F1