Maintenance; Aligning The Blade With The Rails - Carat EASYCOUPNEXT 350 Manual Del Usuario

10 MAINTENANCE

The table saws requires simple maintenance as described below:
 Carfully remove all waste and dirt from the rolling card rails.
 Replace as soon as possible electrical cables that cause power cuts, breaking or any other disrepair.
 If the machine is not under cover, wrap it with an impermeable cloth.
 At the end of each day, unplug the machine.
Maintenance should be undertaken by operators that know the how the machine works.
Before performing any maintenance or cleaning operations, make sure that the electricity cable is unplugged.
In case you observe any anomalies or mal functioning, let a technician check the machine.
Take into account the safety recommendations mentioned in this manual.
It is prohibited to independently make any change in some parts, components or characteristics
of the machine. CARAT shall in no case be responsible for the consequences that may derive from a breach
of these recommendations.
10.1

ALIGNING THE BLADE WITH THE RAILS.

This operation will require using a rod of Ø 4 to 5 mm and 250 mm long, with one end sharpened like a pencil. A
piece of ceramic tile and White chalk will be needed too. Then, proceed as followes:
o Unplug the machine from the power source.
o Remove the guard and the blade.
o Put the tile on the rolling cart (the enamel side downwards), and draw a line with chalk on other tile side,
dividing it in two halves.
o Put the rod between the blade clamps so the sharpened point meets the chalk line drown on the back of the
tile piece. Tighten up the nut on the motor shaft.
o Push the Rolling cart so the rod will trace a straight line on the lile.
o Then turn the motor shaft to shift the rod to the opposite side and pull the cart back to draw a new line, which
should match the first one. If both lines would not match, then loosen up the screws that hold the motor, tap on
the motor shaft on the side that demands correction and repeat the process until the two lines drawn by the rod
coincide. Then tighten up the screws of the motor.
o Replace the blade and the blade guard.
12
ENGLISH