Safety Recommendations - Carat EASYCOUPNEXT 350 Manual Del Usuario

6 SAFETY RECOMMENDATIONS.

All machines with an electric motor must be always plugged in
a standardized electric board equipped with a magneto
thermal switch and a differential switch in accordance with the
motor features. Please, refer to the table below.
VERY IMPORTANT: Always use earth plugs before starting-up the machine.
 Use normalized cables.
 Make sure the feeding voltage is in accordance with the voltage indicated in the adhesive label on the
machine.
 Make sure that the extension cords are not in contact with points of high temperature, oil, water, sharp
edges.
 Do not use high pressure water to clean circuits or electrical elements.
 The damaged electrical cables should be urgently replaced.
 Do not remove from the machine any safety device or protection guard.
 Always use approved protective items (gloves, helmet, goggles, boots ... ..)
 Turn the machine on the network and do not handle or operate on the mechanical and electrical machine with
the engine running.
 Cutting table machines should be used by people who are familiar with its operation.
 It´s not allow to access and manipulation of the machine to people who are not familiar with the machine
before.
 Work clothes should not include loose clothing that could get caught in moving parts of the machine.
 Before starting the machine, read the instructions carefully and observe compliance with safety standards.
Learn well how to stop the machine quickly and safely.
 Place the machine on a flat and well lit and you do not switch the
machine on until it´s got a balance position.
 Make sure the machine is in perfect technical condition and fully operational.
 Do not operate the machine if all the protections and safeguards are assembled which have been designed
for that purpose.
 When moving the machine, always verify that engine and moving parts are blocked.
 Use only diamond blades specified in this manual.
This machine MUST NOT BE USED IN THE RAIN. Cover with waterproof
materials. If the machine has been exposed in the rain check before connecting
the electrical parts are not wet. Always work with good lighting conditions.
Warning: You must follow all safety recommendations outlined in this manual
and comply with regulations for the prevention of occupational hazards of each
place.
CARAT is not responsible for the potential consequences of inadequate use of the table saws.
7
ENGLISH