Tabla de contenido
Maintenance
WolfPac
6100
TM
52
Use a grease gun to grease fittings. Remove the blue protective cap from fitting before
se hand operated grease gun, only.
greasing.
damage may occur.
Hinge (4) fittings
FORWARD/REVER E/NEUTRAL ADJU TMENT
The forward/reverse lever should be aligned with ‘NEUTRAL’ on the console when the roller is
not moving forward or backward with the
engine running. If the lever is not aligned,
adjust it as follows:
Shut off the engine with the
forward/reverse lever left in
operating neutral position, the
position when the roller moves
neither forward nor reverse.
Open the engine hood of the
machine.
Disconnect the linkage from the
hydrostatic transmission. Do this
by removing the jam nut (1) from
the rod end (2).
Loosen the rod end nut (3) and screw rod end (2) in or out to adjust.
Secure the rod end (2) to the transmission lever (4) with the jam nut (1) and tighten
rod end nut (3).
Linkage play must be minimal at both connections. Replace rod end, cable and/or linkage if
required.
NEUTRAL INTERLOCK
The purpose of the neutral interlock switch is to
prevent engine starting when the forward/reverse
lever is not in the neutral position.
Disconnect battery cables from battery.
a. Disconnect two wires from neutral
interlock switch (1) and connect it to
leads from an ohmmeter.
b. When switch is actuated, ohmmeter
Do not use pressurized grease gun or machine
Forward/ evrse/Neutral Adjustment
Neutral Interlock
Tabla de contenido
