Operation
WolfPac
6100
TM
32
OPERATOR CONTROL
E-Stop/Brake Button (Item 1)
his is an emergency stop button to be used in a situation where an immediate stop of the
machine is desired. Pressing this button will stop the engine and machine immediately. his
button, red in color, is located on the key switch plate.
Keyswitch (Item 2)
In the OFF position the electrical control circuits are not powered. In the RUN position all
instruments and electrical control circuits are powered.
Vibe Switch (Item 3)
hree position switch activates lighter or heavier compaction.
Select drum vibe by setting rocker switch to desired vibe,
front, rear or both drums.
Vibe On/Off Button (Item 4)
Machine vibration is accomplished by directing the pump flow
to the hydraulic motor on the eccentric shaft. Vibe rocker
switch selects vibe to the front, rear or both drums.
o start vibration: Push button to initiate vibration ON.
o stop vibration: Push button.
Control Lever (Item 5)
Once the engine is at run speed move forward/reverse lever slowly forward to gain speed
desired. he same procedure is for reverse. o slow down move forward/reverse lever
towards neutral.
o gain power or speed by move the forward/reverse lever slightly off of neutral to produce
the greatest amount of torque. Moving the lever all the way forward or reverse will give the
greatest amount of speed.
Operator Controls
Front Drum
Vibe On
Both Drums
Vibe On
Rear Drum
Vibe On
Vibe Switch Postions