Tabla de contenido
Operation
This symbol is used
to identify an action
that requires
particular attention
and/or care.
WolfPac
6100
TM
26
AFETY YMBOL
afety symbols are used in these instructions to bring attention to actions that may cause
personal injury or damage to the equipment. Always observe these symbols, they are
included for your safety and for the protection of the machine.
DELIVERY IN PECTION
Upon receipt of your roller, CAREFULLY CHECK FOR ANY FREIGHT DAMAGE. Any damage
should be immediately reported to the carrier and a claim registered.
WolfPac 6100 is manufactured to the strictest specifications and inspection procedures. If
any material or manufacturing defects are found, return the tag on the machine with the
assembler’s signature and your findings to the manufacturer. We want to know when a
product is less than perfect. We also welcome any and all input on how the product may
serve you better.
The following instructions were compiled to provide you information on how to obtain long
and trouble free use of the roller. Periodic maintenance of the roller is essential. Read the
manual in its entirety and follow the instructions carefully. Refer to the Technical Data
ection to familiarize yourself with machine controls and components. Failure to do so may
injure yourself or a bystander.
ROP A EMBLY
The WP6100R is not shipped with the ROP assembled. Before operating this machine the
ROP must be correctly installed to protect the operator in case of a machine roll over. Failure
to do so will result in serious injury.
he ROPS must be correctly installed to protect the operator in case of a
. Park the roller on level ground, block drums to prevent roller from moving and
remove key from key switch to prevent starting.
2. Remove rear cover, save
hardware.
3. Place several drops of
Loctite on the bolts ( )
leaving the first three
threads free.
4. Assemble ROPS (2) to
rear frame with hardware
provided(3, 4, 5),
aligning holes in ROPS
and frame, see diagram.
(Make sure keeper is on
the left side.) Torque
eight bolts and nuts to
64 ft/lbs.
5. Reinstall rear cover.
Torque four bolts to 6
ft/lbs.
WARNING
machine roll over.
KEEPER
2
1
5
4
5
3
REAR COVER
Tabla de contenido
