Operation - Jacuzzi BUILDER Serie Manual De Instalación Y Operación

Operation

Note: These instructions pertain to all bath products manu-
factured by Jacuzzi Whirlpool Bath. Not all features discussed
in this instruction pamphlet apply to all baths.
All baths manufactured by Jacuzzi Whirlpool Bath are designed
for "fill and drain," which means the bath should be drained after each
use and filled with fresh water by the next bather. This is a health
precaution, as these baths are not designed to hold water continu-
ously like pools or spas.
Once the bath is installed, remove any residue or foreign materi-
als left over from construction. Use turpentine or paint thinner to re-
move stubborn stains, paint or tar. Other dirt can be cleaned off with
a mild liquid detergent on a damp cloth. Scrape off plaster with a
wooden or plastic edge; do not use metal scrapers, wire brushes
or other metal tools, as they will damage the bath's surface.
Water Level
Close the drain and fill the bath until water is at least 1" above the
highest jet (see water line indicated in the illustration). Do not turn
on the whirlpool system at any time if the jets are not completely
immersed in water. Running the whirlpool system when there is
insufficient water in the bath could result in water spraying outside
the bath area. Running the whirlpool system without water will dam-
age the recirculating pump.
Do not immerse the control panel by overfilling the bath.
TYPICAL BATH FITTINGS
MAGIC TOUCH WHIRLPOOL
FULLY ADJUSTABLE JETS
SUCTION
COVER
WATER RAINBOW
FILL SPOUT (OPTIONAL)
OPERATING INSTRUCTIONS
FILL TO AT LEAST
1" ABOVE HIGHEST JET
ON/OFF SWITCH
AIR CONTROL
KNOBS
DRAIN/OVERFLOW
(OPTIONAL)
®
Magic Touch Whirlpool Switch
The Magic Touch Whirlpool ON/OFF switch, conveniently located
on the bath, allows you to turn the whirlpool system on and off while
in the bath. Simply push down on the switch button to turn on the
whirlpool system. To turn the system off, push down on the button
again.
If your bath has an optional Jacuzzi Whirlpool Bath wall mounted
timer, set it for the amount of time you wish the whirlpool to operate.
Note: When you desire less than 10 minutes of whirlpool action, it is
necessary to turn the timer knob clockwise past the number 10 and
then back to the desired amount. If the whirlpool action does not
begin when the timer is correctly set, it is necessary to push the
Magic Touch switch button.
WHIRLPOOL ON/OFF SWITCH
DEPRESS CENTER ON/OFF
RapidHeat Operation
Once the heater is installed and the whirlpool pump is operating,
the heating function is totally automatic. The heater will help main-
tain the temperature of the water in the bath.
Vacuum Switch
The heater is equipped with a preset vacuum switch which will not
allow the heater to turn ON if the pump is not running with water
flowing through the whirlpool system.
High-Limit Switch
The heater includes an exclusive High-Limit switch. This safety
circuit will not false trip from hot tap water. It will only turn off the
heater if the thermostat fails. To reset, press the button. If the high-
limit trips frequently, contact your Authorized Electrical/Mechanical
Service Provider. Visit our web site at http://www.jacuzzi.com/ to
find a Service Provider.
19
Jacuzzi Whirlpool Bath© K272000AC 12/04
ON/OFF
High-Limit RESET SWITCH