EGO POWER+ HTA2000 Manual De Instrucciones página 11

If no grease can be seen on the flanks of the gear, follow
the steps below to fill with gear grease up to 3/4 capacity.
Do not completely fill the transmission gears.
1. Depending on which screw you are removing, hold
the hedge trimmer on its side or lay it on its back
so that the sealing screw to be removed is facing
upwards (Fig. O & P).
2. Use the wrench provided to loosen and remove the
sealing screw.
3. Use a grease syringe (not included) to inject some
grease into the screw hole; do not exceed 3/4
capacity.
4. Tighten the sealing screw after injection.
STORING THE UNIT
◾
Remove the battery pack from the tool.
◾
Clean the tool thoroughly before storing it.
◾
Put on the blade scabbard onto the cutting blade
before storing or transporting. Use caution to avoid
the sharp teeth of the blades. For saving space, it is
recommended to fold the hedge trimmer to its storage
position (see Fig. B).
◾
If the hedge trimmer is removed from the power
head and stored separately, fit the end cap on the
attachment shaft to avoid dirt getting into the coupler.
◾
Store the unit in a dry, well-ventilated area, locked-up
or up high, out of the reach of children. Do not store
the unit on or adjacent to fertilizers, gasoline, or other
chemicals.
Protecting the environment
Do not dispose of electrical equipment,
battery charger and batteries/
rechargeable batteries into household
waste!
According to the European law 2012/19/
EU, electrical and electronic equipment
that is no longer usable, and according to
the European law 2006/66/EC, defective
or used battery packs/batteries, must be
collected separately.
If electrical appliances are disposed of in
landfills or dumps, hazardous substances
can leak into the groundwater and get
into the food chain, damaging your health
and well-being
EC DECLARATION OF CONFORMITY
We, EGO EUROPE GMBH.
Wahlwiesenstrasse 1, D-71711 Steinheim an der Murr
Deutschland
Declare that the product 56V lithium-ion cordless hedge
trimmer attachment HTA2000, equipped with power
head PH1400E
Complies with the essential health and safety require-
ments of the following Directives:
2006/42/EC, 2014/30/EU, 2011/65/EU, 2000/14/EC
Standards and technical specifications referred to:
EN 60745-1, EN ISO 10517, EN 55014-1, EN 55014-2
Measured Sound Power Level: 92.3 dB(A)
Guaranteed Sound Power Level: 95 dB(A)
* (The above parameters are tested and measured equipped with the power head)
Peter Melrose
Managing Director of
EGO Europe GmbH
* (Authorized representative for CHERVON and responsible for technical documentation)
01/12/2016
HEDGE TRIMMER ATTACHMENT — HTA2000
EN
Dong Jianxun
Quality Manager of
Chervon
11