Checklist For Installation; Installation Location; Dryer Dimensions - Bosch Vision 300 Serie Manual Del Usuario

Installation location
DO NOT install the dryer:
outdoors
in an environment with dripping
water,
near flammable materials,
in rooms which are at risk of frost,
in rooms which may contain gas
or other fuels,
in cupboards with Iockable doors.
The installation room must be well
ventilated, otherwise the dryer will
operate below optimum performance.
Do not operate the dryer at
temperatures above 104°F (40°C) or
below 41 °F (5°C). Low temperatures
affect the automatic program sequence
and may prolong the drying times.
The installation surface for the dryer
must be clean, level and firm. Do not
install the appliance on carpets!
Compensate for uneven floors with the
height-adjustable feet.
The size of the installation area
depends on the dimensions of the
dryer. Ensure that there is adequate
room for the swivel range of the door!
Dryer Dimensions
Dimension Weight
a 27,0" (68,6cm) 125 Ibs
b 31,8" (81,0cm) (56,7 kg)
c (min)* 36,9" (93,6cm) with
packaging
c 37,8" (95,9cm) 143 Ibs
(max)* (64,8 kg)
d 22,0" (59,7cm)
angle 160 °
e 53,9" (136,9cm)
* min=dryer feet all the way in, max=out
Useful Tools
The following tools are helpful during
installation:
1. T20 star head screwdriver
2. Philips screwdriver (#2)
3. Flat blade screwdriver
4. Open end wrench 1 in. (25mm)
5. Bubble level
1
3
Checklist for Installation
1. Unpack the dryer.
2. Remove all objects from the drum.
3. Check the dryer for visible
damage.
4. Position the dryer near the
installation location (see page 8).
5. If required, change the door hinge
to the left (see page 9).
6. If required, install the side or
bottom exhaust air outlet on the
dryer (see page 19).
7. Have the power supply cord fitted
by a qualified technician or a
licensed electrician (see page 14).
,
Check for "Y" connection, short
hose and water supply hose
included with the dryer packaging
(see page 13). (Selected models
only).
,
Connect the water supply
(selected models only) to the back
of the dryer (see page 13 for
detailed instructions).
10. Install exhaust ductwork if
necessary.
%
Follow the installation instructions
supplied by the appropriate
ductwork parts manufacturers (see
page 18)
If space is very restricted, it is
recommended to fit the initial parts
of the exhaust duct to the dryer
before the dryer is moved to its
final installation location.
DO NOT push against the dryer
door glass. Risk of breakage!
Do not
push against
the do6r glass!
11. Move the dryer to its final location.
Do not slide dryer across the
floor if height-adjustable feet
have been extended. Feet and/or
dryer base may be damaged if
dryer is slid across floor with
height-adjustable feet extended.
12. Position and then level the dryer.
-i!iiiiii!i_!ii_!_i!i_>_ ¸ ii!_!__ii_ii_
J
LJ
/
The dryer should be level with all four
feet firmly on the ground. The dryer
must not wobble. If the dryer is not level
or if it does wobble, the feet must be
adjusted. Adjust the height-adjustable
feet using the 1 in. (25mm) wrench until
the dryer does not rock and is level,
both front-to-back and side-to-side.