Hilti RT 6-A22 Manual De Instrucciones página 20

▶ Do not look directly into the light source (LEDs) of the power tool and do not aim the beam at other
persons' faces. Risk of dazzling or eye damage.
Safety at the workplace
▶ Ensure that the working area is well lit.
▶ Keep the workplace tidy. Objects which could cause injury should be removed from the working area.
▶ Wear non-skid shoes.
▶ You and any other persons in the vicinity must wear suitable eye protection, a hard hat, ear protection
and protective gloves while the tool is in use.
▶ Keep the tool and blind rivets locked away when not in use, and always keep them out of reach of
children.
▶ Keep children and other persons away from the working area.
▶ Avoid unusual body positions. Keep proper footing and balance at all times.
▶ Before driving fasteners, check that no one is present on the other side of the sheet metal to be fastened.
▶ Take the influences of the surrounding area into account. Do not use the tool where there is a risk of fire
or explosion.
2.1.3 Battery use and care
▶ Observe the special regulations and instructions applicable to the transport, storage and use of Li-ion
batteries.
▶ Do not expose batteries to high temperatures, direct sunlight or fire.
▶ Do not disassemble, crush or incinerate batteries and do not subject them to temperatures over 80 °C.
▶ Do not use or charge batteries that have suffered mechanical impact, have been dropped from a height
or show signs of damage. In this case, always contact your Hilti Service.
▶ If the battery is too hot to touch it may be defective. In this case, place the product in a non-flammable
location, well away from flammable materials, where it can be kept under observation and allowed to
cool down. In this case, always contact your Hilti Service.
3 Description
3.1 Overview of the product
3.2 Items supplied
Blind-rivet setting tool, 4 nosepieces, wrench, removable mandrel container, operating instructions.
Other system products approved for use with this product can be found at your local Hilti Store or online at:
www.hilti.group.
3.3 Intended use
The product described is a hand-held cordless blind-rivet setting tool.
▶ Use only Hilti Li-ion batteries of the B22 series with this product.
▶ Use only Hilti battery chargers of the C4/36 series for these batteries.
16 English
Printed: 30.07.2019 | Doc-Nr: PUB / 5466619 / 000 / 02
1
@
;
=
%
&
(
)
+
§
/
:
∙
$
Nosepiece
Steel sleeve
Jaw housing
Jaws
Jaw pusher
Pressure spring
Adapter
Mandrel container
Battery charge-status and fault indicator
Battery release buttons (also used to activate
the charge status indicator)
Battery
Light source / overload LED
Switch
2225140
*2225140*