Idiomas disponibles
Idiomas disponibles
FIXING THE SIDE PANEL
9
- Having fixed the channel to the wall, seal on the inside, at the
A
meeting with the bathtub rim.
9
- Apply sealant to the bottom of the side panel, where indicated.
B
9
- Position the panel on the bathtub, locating the edge in the
C
channel and the pins in the rim holes.
9
- Secure the panel to the bathtub with the screws, nuts and
D
washers.
FITTING THE DOOR
10
- Undo the fixing screw, and remove the terminal from the
A
top of the panel.
10
- Fit the door, locating one end on the bottom terminal of
B
the panel and anchoring the other to the top terminal with
the screw removed previously.
FIXING THE CROSS RAIL
11
- Fit the cap to the cross rail.
A
11
- Connect the hose 6 for the vertical massage jets.
B
11
- Secure the cap with the screw as indicated.
C
11
- Ensure the side panel is plumb, then secure the cross rail
D
with the screws and spacer.
11
- Slide the previously assembled seal toward the column,
E
and press home.
CHECKING THE PLUMBING CONNECTIONS
Having made all the connections, start up the system as described
in the accompanying user manual.
Check that there are no leaks at the fittings and that everything
works as it should.
FIXING THE HYDROSHOWER TO THE FLOOR
-
12
Anchor the bathtub to the floor by fixing the feet as
indicated in the drawing, using the screws and
masonry plugs provided.
FITTING THE PANELS
-
13
Refit the panels by repeating the removals steps in reverse order (2-1):
A
- offer the panel to the bathtub
- press the top edge of the panel inwards so that it locates
between the springs and the rim of the tub.
- press forward on the lower part of the panel near the clips, so
that these engage in the relative sockets.
13
- Raise the panels using the wedge (A) provided.
B
- Secure the panels with the screws and collars (B).
- Snap the concealers (C) onto the collars.
FITTING THE TRIMS
-
14
The trims kit is suitable both for a built-in tub (14A) and for a corner
tub (14B); use only the pieces needed.
L1 =790 - Cut to length as indicated
L6 =790 - Cut to length as indicated
L3 =1560 - Cut to length as indicated = 1515
L4 =1560 - Cut to length as indicated = 1545
L2 + L5 = 1660 Cut in two pieces, each to length as indicated
Apply silicone sealant to the faces in contact with the wall and with
the hydroshower.
Fit the trims with the relative angles and terminals, being certain to
ensure faultless contact with the hydroshower and with the wall.
Apply adhesive tape to hold the trims correctly in place; wait at least
4 hours, then remove the tape and clean off excess sealant.
25
