Recommended Accessories
Use only Dremel accessories. Follow instructions that accompany accessories. Use of improper accessories may cause hazards.
LEG SET
Magnifier
Cat. No.
Cat. No.
2615018500
2615018505
Cat. No.
Suggested Usage
16412
For cutting wood 3/8" to 2" thick
16411
For cutting wood 3/16" to 1" thick
16413
For cutting wood thinner than 1/4" thick
The Pin-End blades, while somewhat easier to put in and take out of the machine, do not always produce the same controlled cut-
ting action provided with the Plain-End blade. These narrow Plain-End blades allow the user to cut more detailed, intricate patterns
and smaller inside cuts.
Cat.No.
Suggested Usage
16453
For cutting hard and soft woods 1/4" to 2" thick
16446
For close radius cutting in materials 1/8" or thicker
16440
Cat. No.
Suggested Usage
16463
For wood, plastic and abrasive materials
For cutting precious and non-ferrous metals; these must be used at very slow speeds.
Cat. No.
Suggested Usage
16483
Metals and other hardwood materials.
Provides a smooth, splinter free finish. Eliminates the need for excessive finish sanding,
and leaves a clean sharp edge on both the top and bottom of your workpiece.
Cat. No.
Suggested Usage
16431
For cutting hard or soft woods up to 1/8" thick.
16432
For cutting hard or soft woods 1/8" or thicker
Dremel offers both Pin- and Plain-End 5 inch blades.
PIN-END SAW BLADES
Pin-End blades permit relatively tight radius cutting in hard and soft wood.
Saws in all directions without turning the workpiece.
METAL PIERCING
They perform well on machines that have variable speed capability and
should be lubricated with beeswax, or a light machine oil.
REVERSE TOOTH
Width Thick
.110" x .018" x 10
.110" x .018" x 15
.070" x .010" x 18.5
PLAIN-END
Width Thick
.062" x .020" x 9.5
.038" x .016" x 12.5
.022" x .010" x 28
SPIRAL
Kerf
.034" - .036" x 41
Kerf
.033" x .016" x 36
Kerf
.029" x .012" x 20
.038" x .016" x 12.5
21
TPI
Speed
Any
Any
Any
TPI
Speed
High
High
High
TPI
Speed
TPI
Speed
Low
TPI
Speed
Any
Any