Troubleshooting - Dremel 1800 Manual De Instrucciones

Turn power switch to "OFF" (O) and always remove plug from the wall outlet before troubleshooting.
WARNING
!
TROUBLE
Breaking blades.
Jammed disc sander
Motor will not run.
Vibration
NOTE: There will always be
some vibration present when
the saw is running because of
motor operation.

Troubleshooting

PROBLEM
1. Wrong tension.
2. Over working blade.
3. Wrong blade application.
4. Twisting blade in wood.
5. Incorrect teeth per inch.
1. Material jammed in disc.
1. Defective cord or plug.
2. Defective motor.
3. Defective wire connections.
4. Brushes worn.
1. Improper mounting of saw.
2. Unsuitable mounting surface.
3. Loose table or table resting
against motor.
REMEDY
1. Adjust blade tension, see REMOVING AND
INSTALLING BLADES, Pages 14 & 15.
(Pin End) or (Plain End).
2. Reduce feed rate, see BASIC Scroll Station OPERA-
TION, Page 14.
3. Use narrow blades for cutting thin wood, wide blades
for thicker wood.
4. Avoid side pressure on blade - avoid over-tensioning
pin-end blade.
5. Blade should have minimum 3 teeth in contact with
workpiece.
1. Turn off and unplug saw.
Remove material.
1. Replace defective parts before using saw
again.
2. & 3. Consult Dremel Service. Any attempt to
repair this motor may create a HAZARD
unless repair is done by a qualified service
technician. 4. Replace both brushes.
1. See MOUNTING YOUR Scroll Station,
Pages 12 & 13.
2. The heavier your work bench is, the less vibration will
occur. A plywood workbench will not be as good a
work surface as the same size solid lumber. Use
common sense in choosing a mounting surface.
3. Tighten table wing knob.
20