Switching On/Off; Working Instructions - Ferm TSM1035 Manual Original

Attachment of the mitre guide
Fig A1
• Slide the guide in the slot of the table at the left
side of the sawblade Fig.A1
Assemble or change the saw blade
Fig G
First remove the plug from the mains
before the saw blade is assembled or
replaced.
The arrow marked on the saw blade,
which indicates the direction of rotation,
must point in the same direction as the
arrow marked on the machine, the saw
blade teeth must point downwards on
the front of the saw.
• Remove the inlay (21) from the table, by
using a screwdriver. Fig.G1
• Turn the saw blade completely upwards.
(Instructions for height adjustment see chapter 4) • Loosen the nut with the wrenches (14) (Fig.G2)
• Remove the nut and the outside flange from
the sawblade axle. (Fig.G3)
• Slide the old saw blade over the saw blade
axle and put on a new saw blade.
• Put the outside flange back on add the nut.
• Tighten the nut by using the wrenches.
• Put the inlay back in the table and tighten
the screw.
4. OPERATION

Switching on/off

Fig A1 (8)
• Press the switch into position '1' to put your
machine into operation.
• To switch off the machine the same switch
needs to be pressed to position '0'
• Always keep the mains cable away from
moving parts.
Using the 2 in 1 handle, Adjust the angle and
height of the saw blade
Fig A2
Using the height adjustment
• Turn the handle (9) clockwise to raise the
sawblade
• Turn the handle counter clockwise to lower the
sawblade
12
• Make sure the saw blade is always
approximately 2 mm higher than the total
thickness of the material to be sawn.
Using the angle adjustment
Fig G4
• Slightly loosen the knob(10)
• Press the handle(9) towards the machine and
turn counter clockwise to adjust the sawblade
in its angle.
• Fasten the knob(10)
Using the parallel guide
Fig A1, E, J1, J2
The parallel guide (2A) is equipped with a guide
extension (2B). The guide extension can be used
in two different ways, depending on the thickness
of the wood.
For thicker wood, the guide extension (2B) should
be mounted as shown in figure J1.
For thinner wood, the guide extension (2B) should
be mounted as shown in figure J2.
• Unlock the guide down by pushing the handle
upwards (Fig.E)
• Slightly loosen the wing nuts (2C)
• Remove the guide extension (2B) from the
parallel guide (2A) by sliding it away from the
parallel guide
• Turn the guide extension to the desired
position and slide it back onto the parallel guide
• Tighten the wing nuts (2C)

Working instructions

There are two types of sawing methods:
• Lengthwise sawing (Fig.H1)
Sawing the workpiece in the length of the
wood grain
• Cross-cutting or cutting off, use the mitre
guide (Fig.H2)
Sawing off the workpiece crosswise
For both sawing methods one of the
fences must be used. Therefor never saw
without a fence!
Attention! Before you start sawing, first check the
following:
1. Is the saw blade secured?
2. Are all the locking handles secured?
3. Is the fence parallel to the saw blade?