Tabla de contenido
Idiomas disponibles
Idiomas disponibles
After each cycle
IV
IMPORTANT: Allow the unit to cool for at least
two minutes before removing the steriliser from
the microwave.
1. Removing the steriliser from the microwave: After
the unit has cooled, remove it from the microwave
by holding the skirt and/or safety grips and then
place on an even, heat resistant surface.
NB: Items will remain sterile in the Microwave Steam Steriliser
for up to 24 hours providing the lid is not removed.
2. After removing the steriliser from the microwave:
Remove the lid by unlocking the clips – When
removing the lid, point it away from you to allow
steam to escape.
Care and cleaning
• Always drain the excess water from the unit
and rinse to prevent the build up of limescale.
• Always store when completely dry.
• The Microwave Steam Steriliser is dishwasher safe.
Loading one VIA Feeding System* and up to
E
four 180ml/6oz OR 240ml/8oz VIA Cups and Lids
1. Position the teat in an outer teat cavity.
2. Place the screw ring over the teat.
3. Position the VIA Cups upside down around
the dome cap stem.
4. Place the VIA Adaptor on its side around the
racks edge (as shown).
5. Position the VIA Lids vertically around the racks
edge. Rims should face out for easier loading.
6. Place the dome cap in the unobstructed upper
slot of the dome cap stem.
Loading other feeding and baby product items
When sterilising other NON-ELECTRICAL PRODUCTS
simply place the components in the rack allowing
enough space so that steam can effectively circulate.
* Consists of VIA Cup, Lid and Adaptor, an Extra Soft Slow
Flow teat, dome cap & screw ring.
WARNINGS – FAILURE TO FOLLOW INSTRUCTIONS MAY
CAUSE SCALDING OR DAMAGE TO THIS PRODUCT AND/
OR YOUR MICROWAVE
•
Wash your hands before handling your
sterilised products.
•
Always ensure you use 200ml of water before
sterilising. (The unit should be emptied of residual
water before each subsequent use.)
•
Always follow loading instructions and do
not overload.
•
Do not use bleach or chemical sterilising solutions
/tablets in steriliser or on products to be sterilised.
•
Do not sterilise metallic or electronic items
in the steriliser.
•
Always use the appropriate heating time for the
power of your microwave unit. (see Table
•
In combination ovens, ensure grill is switched off
and has cooled before use.
•
Be sure that the lid is properly fastened to
the base before placing in microwave.
•
Always allow at least 2 minutes cooling time
before removing from the microwave.
•
Do not remove the lid from the steriliser
immediately after cycle. Allow to cool as the steam
will be hot.
•
When removing from microwave, be sure to hold
the steriliser level to avoid leaking or spilling of
hot water.
•
When taking the steriliser out of the microwave,
TAKE CARE – it will still be hot.
•
When removing the lid, point it away from you to
allow steam to escape.
•
Take care when handling the sterilised products as
they may be hot.
•
Do not rinse the bottles when you remove them
from the steriliser.
•
Always keep out of reach of children.
•
Do not microwave bottle brush.
NB: Do not overload the steriliser.
NB: Do not place dome caps in the steriliser upside down.
NB: The Microwave Steam Steriliser is designed to
specifically hold the wide shape of AVENT Feeding
Bottles.
Some products featured may not be available
in all countries. Please contact Philips AVENT
to check availability.
Philips AVENT is here to help
GB: Call FREE on 0800 289 064
IRL: Call FREE on 1800 509 021
AU: 1 300 364 474
www.philips.com/AVENT
GB
III
)
9
Tabla de contenido
